Kolpin 20044 Guide Rapide

Saw Press II Assembly:
1. Attach the Hinged Plates to the mounting Bracket using the three (3) .25" x .50" long bolts, and
three (3) .25" Nylock nuts.
2. The Hinged Plates can be set at 45 degree angles to accommodate your ATV and Saw.
3. Place the 1" OD Washer on the Hand Knob and thread through the swivel in the hinged plates.
Install the 3/8" Nylock nut on the exposed thread of the hand knob and tighten so the nut is even
with the end of the end of the threads. This nut prevents the Hand Knob from loosening and
falling out of the swivel.
Note: Extra hardware is provided to accommodate different racks. Some hardware
may have to be cut down for clearance between the rack and the fender deck.
Saw Press II Mounting:
1. Attach the Saw Press II to the rack of your ATV using (3) Plastic cross braces under the rack and
the desired length .25" bolts with washers through the plate and into the nuts in the cross braces.
Note:
Saw Press II Use:
•
The Saw Press II is designed to carry your saw safely and securely while keeping your ATV rack
open for other necessities.
•
Place the saw into the Kolpin Saw Press II and push the front plate closed. Swing the Hand Knob
into the slot in the front plate, tighten securely. To open, loosen the Hand Knob and pivot the
hand knob to release the front plate.
•
The flanges on the front plate are designed to help keep branches from hitting and possibly
opening the Hand Knob.
Caution: Door may swing open causing the saw to fall out. Make sure to hang onto saw when
opening the Saw Press II.
www.kolpinpowersports.com customerservice@kolpin.com
Alternative Mounting:
Rev. 3
20044 Saw Press II
The .25" Square Nuts get placed in the slots of the Cross Braces.
Kolpin Powersports, Inc.
205 N. Depot Street, Fox Lake, WI
Phone #: (877) 9KOLPIN or (920) 928-3118
DESCRIPTION
Mounting Bracket
Hinged Plates
.25" x .50" Bolt *
.25" x 2.25" Bolt *
.25" x 4" Bolt *
.25" Nylock Nut *
.25" Square Nut *
Plastic Cross Braces *
.25" Washers *
Hand Knob *
Washer 1" OD 3/8" ID *
3/8" Nylock Nut *
* Denotes what is included in the hardware pack.
Use this Spare P/N 70044 to order parts.
QTY.
1
1
3
6
6
3
6
3
6
1
1
1