Installation Instructions; Part Numbers - Reese Towpower 51232 Instructions D'installation

Masquer les pouces

page de 6

/ 6
Signets

Les langues disponibles

Note: Do Not use both Hitches

at the same time.

This may overload and

cause damage to vehicle.

Driver's side

frame rail

Existing Access

hole

Forward

hole

Note: Fasteners typical both sides

Optional Installation Without existing O.E.M. Class 2 Integrated Hitch/Bumper. See previous page for vehicles with O.E.M. hitch

Carriage Bolt 7/16 – 14 X 1.75 GR5

Qty. (6)

Block

Qty. (6)

Conical Washer

1. Use pullwire to feed 7/16 - 14 carriage bolt and block using the kink pullwire method (Figure 2) into the forward hole, using the

access hole on the passengers frame rail. (See Figure 4)

2. Use the pullwire to feed 7/16 - 14 carriage bolt and block into the forward drivers frame rail using existing access hole. (As shown

(Figure. 4))

Note: be careful not to push fasteners back into frame.

3. Raise hitch into position and onto carriage bolts and attach with conical toothed washers and nuts. Hand tighten the fasteners.

4. Use pullwire on remaining 7/16 – 14 carriage bolts and blocks into each frame rail (2 each side) using the same access holes as in

Step 1 & 2. (See Figure 4)

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.

This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.

2012 Cequent Performance Products, Inc. - Printed in Mexico