Getting Started; Insert The Batteries; Units Of Measurement; Using The Tare Function (Tare) - Xavax JEWEL Mode D'emploi

5. Getting Started

5.1 Insert the batteries:

Open the battery compartment on the back and insert two
CR2032 button cell batteries. Make sure that the polarity (+/-)
is correct. The positive pole (+) must point upwards. Close the
battery compartment fully.

5.2 Units of measurement

The following units of measurement are available: g (gram),
ct (carat), gn (grain), oz (ounce), ozt (troy ounce) and dwt
(pennyweight). Press the Unit button to select one of the units
of measurement in the given order: g-ct-gn-oz-ozt-dwt-g.
5.3 Weighing
• Place the scales on a clean, level table. Make sure that the
scales are stable and do not tilt.
• Switch on the scales by pressing the Power on/off button.
Initially all symbols appear on the display. Please wait until
'0.0 g' appears. You can then place the item to be weighed
onto the scales and read the weight value.

5.4 Using the tare function (TARE)

• Place the empty container onto the scales; the weight is
shown on the display. Set the scales to zero by pressing the
TARE button. Now place the new item to be weighed (in the
container) onto the scales. Only the net weight of the item
(its weight without the weight of the container) is shown.
Once the display stops changing, the scales automatically
switch off after approximately 60 seconds. You can manually
switch off the scales by pressing and holding down the Power
on/off button.
6. Error messages
• When the error message 'O-Ld' is shown, the scale is
overloaded.
• When the error message 'LO' is shown, the battery is
empty. Replace the battery as soon as possible.
7. Care and Maintenance
• Only clean this product with a slightly damp, lint-free cloth
and do not use aggressive cleaning agents. Make sure that
water does not get into the scales.
• The weighing surface is made of stainless steel.

8. Warranty Disclaimer

Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
9. Technical Data
The high-precision strain gauge sensor and the powerful
processor ensure extremely precise weighing.
Max. weight
Min. weight
Scale division
Units of
measurement
Low battery and overload warning
Power supply
500 g
1 g
0,1 g
g, ct, gn, oz,
ozt, dwt
2x CR 2032
3