COZY W255G Instructions D'installation Et D'utilisation page 18

WARNING:
A. This appliance has a pilot which must
IF YOU DO NOT
FOLLOW THESE
B. BEFORE LIGHTING smell all around
INSTRUCTIONS
EXACTLY,
A FIRE OR
EXPLOSION
MAY RESULT
CAUSING
WHAT TO DO IF YOU SMELL GAS:
PROPERTY
DAMAGE,
PERSONAL
INJURY OR
LOSS OF LIFE.
1. STOP! Read the information on the safety label.
2. Turn temperature control knob clockwise
"LO".
3. Open cabinet door.
4. Depress and turn gas control knob clockwise
"OFF".
Gas Control Knob
PILOT ADJ
NOTE: Knob cannot be turned from "PILOT" to "OFF"
unless knob is pushed in slightly. Do not force.
5. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you smell gas,
STOP! Follow "B" in the information on the safety
label. If you don't smell gas, go to the next step.
6. Locate the pilot. (Follow metal pilot tube from gas
control).
7. Turn gas control knob counterclockwise
"PILOT".
1. Turn temperature control knob clockwise
"LO".
2. Open cabinet door.
BBSK KIT LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
be lighted by hand. When lighting the
pilot, follow these instructions exactly.
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
• DO NOT try to light any appliance.
• DO NOT touch any electric switch;
DO NOT use any phone in your
building.
• Immediately call your gas supplier from
a neighbor's phone. Follow the gas
LIGHTING INSTRUCTIONS
to
to
to
TURNING OFF GAS TO APPLIANCE
to
Page 17
supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools. If
the knob will not push in or turn by hand,
don't try to repair it, call a qualified service
technician. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has
been under water. Immediately call a
qualified service technician to inspect the
appliance and to replace any part of the
control system and any gas control which
has been under water.
8. Depress gas control knob & hold in. Immediately
light the pilot with a match. Continue to hold the gas
control knob in for about one (1) minute after the pilot
is lit. Release gas control knob and it will pop back up.
Pilot should remain lit. If pilot goes out, repeat steps 4
through 8.
• If knob does not pop up when released, STOP and
immediately call your service technician or gas
supplier.
• If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your service
technician or gas supplier.
9. Turn gas control knob counterclockwise
10. Close the cabinet door.
11. Turn temperature control knob to desired setting.
3. Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
4. Close cabinet door.
Back to Index
Pilot is
located
on side of
burner
to "ON".
1017754-A