Go 3313 : Presentation; Use For Intended Purpose; Working Range - Degometal GO 3313 Consignes De Sécurité Et Mode D'emploi

1. GO 3313 : PRESENTATION

Use for intended purpose

The blind rivet nut setting tool must only be used for the purpose of setting blind rivet nuts as described
in these operating instructions. Observe the safety information!
CAUTION
Safety information
!
The following safety rules must be observed to ensure adequate protection against electric
shock, injuries or fire hazards.
●
The blind rivet nut setting tool is intended solely for the purpose of processing blind rivet nuts.
Never overload the blind rivet nut setting tool; work within the specified working capacity.
●
Never use the blind rivet nut setting tool in a humid or wet environment or close to flammable liquids
●
or gases. Danger of explosion!
●
Ensure that the battery is properly secured in the handle.
Always remove the battery when the blind rivet nut setting tool is not in use and for maintenance.
●
●
Never use the blind rivet nut setting tool as a hammer.
●
When not in use, keep the blind rivet nut setting tool in a dry, closed room and out of the reach of
children.
Always wear protective goggles when working with the blind rivet nut setting tool. Personal protective
●
equipment such as protective clothing, gloves, safety helmet, non-slip footwear, ear protection and fall
arresting device is recommended.
●
The air inlets for the motor must not be obstructed; do not insert any objects into them.
When setting down the blind rivet nut setting tool, make sure that itcannot fall.
●
●
Use only genuine spare parts for repair.
Repairs must be carried out only by skilled personnel. In case of doubt, always send in the blind rivet
●
nut setting tool to the manufacturer.
Do not use the tool without material! The blind rivet nut could be flung from the blind rivet nut setting
●
tool! Never turn the blind rivet nut setting tool towards yourself or towards other persons

Working range

Sets blind rivet nuts up to M10.Alu, Steel, Stainless St.
Equipment / Accessories
Nosepieces:
Wrench:
Hanger:
Battery charger: 230 V, 50 Hz
Quick-charge battery: 60 or 90 minutes
M6 in working position
M4, M5, M8, M10 in accessory magazine
Hexagon screwdriver WAF 4
Concealed in housing
www.degometal.com
!
17