Flex MS 1706 FR Notice D'utilisation page 18

Note
The rough side of the quick-release
clamping nut always faces the cutting disc
or distance washer.
5. Remove the cutting discs (b), clamping
flange (d) and distance washers (c).
To change the cutting discs:
n Attach new cutting discs (b), distance
washers (c) and clamping flange (d) in
reverse sequence.
n Screw on the quick-release clamping nut
(a). Depress the spindle lock (12) and
manually tighten the quick-release
clamping nut (a).
To change the groove width:
The groove width can be set by rearranging
the distance washers.
Note
The minimum groove width is 10 mm. In all
distance washers (c) are fitted in front of the
quick-release clamping nut (a).
18
All manuals and user guides at all-guides.com
n Attach the cutting disc (b), distance
n Attach the remaining distance washers
n Screw on the quick-release clamping
6. Gently depress the milling unit and
7. Lift lock (5) for guard hood and rotate
8. Insert the mains plug into the socket.
9. Switch on the wall chaser (without
Wall chaser MS 1706 FR
washers (c) according to the required
groove width and clamping flange (d).
(c).
nut. Depress the spindle lock (12) and
manually tighten the quick-release
clamping nut (a).
attach the guard hood (3).
by 180° until it engages.
locking the switch) and leave running for
approx. 30 seconds. Check for quiet
running.