Automatic Power Off Function; Cleaning And Maintenance - ARTHUR MARTIN AMP75 Manuel D'instructions

8. Please follow the operation as below to avoid the steam outlet being blocked after finish frothing
milk each time: put an empty jug under the steam band, then turn on the steam knob and press
down the pump control button " " to the lower position, the pump will pump water, after the water
flowing out for 30 seconds, press the pump control button " " to the higher position, finally, clean
the steam outlet with wet sponge, but care not to be burnt!
9. Press and release the ON/OFF button " " to cut off the power source.
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the steam knob
to "O" position and make the coffee maker cool down for about half an hour, then poke the steam
outlet for several times with a needle about 1mm in diameter, finally, press down the coffee/steam
button " " and turn on the steam knob to check if the appliance can produce steam normally when
the steam indicator (green) illuminates. Please contact the service department if the appliance can
not produce steam after operate as above.
Note: after steaming, we recommend you allow the maker to cool down at least for 5 min before
making coffee again. Otherwise burnt odor may occurred in your Espresso coffee. If you want to
make coffee immediately, follow the next steps: First, press and release the steam button " " to the
higher position; dip the steam wand into a cup; secondly, press the pump control button " " down
to the lower position and turn on the steam control knob and there will be water flow out from steam
wand ; after the ready indicator extinguish, press and release the pump control button " " to the
higher position, then turn the steam control knob to "O" position. When the ready indicator
illuminates, you can start to brew coffee again.

AUTOMATIC POWER OFF FUNCTION

The appliance will turn off automatically if there is no any operation within 29 minutes.

CLEANING AND MAINTENANCE:

1. Cut off power source and let the coffee maker cool down completely before cleaning.
2. Clean housing of coffee maker with moisture-proof sponge often and clean water tank, drip tray
and removable shelf regularly then dry them.
Note: Do not clean with alcohol or solvent cleanser. Never immerse the housing in water for
cleaning.
3. Detach the metal funnel by turning it clockwise, get rid of coffee residue inside, then you can
clean it with cleanser, but at last you must rinse with clear water. Do not wash the metal funnel in a
dishwasher.
4. Clean all the attachments in the water and dry thoroughly.
Note: Clean the appliance after every use in order to make it work properly.
CLEANING MINERAL DEPOSITS
1. To ensure your coffee maker can operate efficiently, internal piping is clean and the peak flavor of
coffee, you should clean away the mineral deposits left every 1-2 months.
2. Fill the tank with water and descaler to the MAX level (the proportion of water and descaler is 4:1)
details refer to the instruction of descaler. Please use "household descaler", you can use the citric
21