ARTHUR MARTIN AMP75 Manuel D'instructions page 22

may increase the potential of the risk of explosion.
6. When the required purpose is reached, you can turn the steam knob to the "O" position.
7. Please follow the operation as below to avoid the steam outlet being blocked after finish frothing
milk each time: put an empty jug under the steam band, then turn on the steam knob and press
down the pump control button " " to the lower position, the pump will pump water, after the water
flowing out for 30 seconds, press the pump control button " " to the higher position, finally, clean
the steam outlet with wet sponge, but be careful not to be burnt!
8. Press and release the ON/OFF button " " to cut off the power source.
9. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. Sweeten if
desired, sprinkle the froth with a little cocoa powder.
Note: Please follow the operation as below if the steam outlet is blocked: firstly turn the steam knob
to "O" position and make the coffee maker cool down for about half an hour, then poke the steam
outlet for several times with a needle about 1mm in diameter, finally, press down the coffee/steam
button " " and turn on the steam knob to check if the appliance can produce steam normally when
the steam indicator (green) illuminates. Please contact the service department if the appliance can
not produce steam after operate as above.
Note: after steaming, we recommend you allow the maker to cool down at least for 5 min before
making coffee again. Otherwise burnt odor may occurred in your Espresso coffee. If you want to
make coffee immediately, follow the next steps: First, press and release the steam button " " to the
higher position; dip the steam wand into a cup; secondly, press the pump control button " " down
to the lower position and turn on the steam control knob and there will be water flow out from steam
wand ; after the ready indicator extinguish, press and release the pump control button " " to the
higher position, then turn the steam control knob to "O" position. When the ready indicator
illuminates, you can start to brew coffee again.
FROTHING MILK/PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk and make hot beverages like drinking chocolate, water or
tea.
Method:
1. Remove the removable tank and fill it with desired water, the water level should not exceed the
"MAX" mark in the tank. Then insert the tank into the appliance properly.
2. Then connect the appliance to power supply.
3. Press down the ON/OFF button " " to turn on the unit, the power indicator (red) illuminates.
4. Press down the pump control button " to the lower position, make sure the coffee/steam
"
button " " is at the higher position, the pump will pump water, when there is water flowing out,
close the pump immediately.
5. Press down the coffee/steam button" " to the lower position and wait for a moment, the
appliance begins to heat until the (green) lamp illuminates, it means the heating is finished.
6. Dip the steam wand into the liquid to be heated. If you want to froth milk, dip the steam wand
about 2 centimeters into the milk. Turn the steam knob in anti-clockwise slowly to start making
steam.
7. Then the desired result is got, you can turn the steam knob to the "O" position.
20