Make Espresso Coffee - ARTHUR MARTIN AMP75 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6. Connect into power source, press down the ON/OFF button "
indicator (red) will be illuminated.
7. Press down the pump control button"
flowing out and close the pump by pressing the pump control button"
8. Make sure the coffee/steam button"
appliance begin preheating until the coffee indicator (green) illuminates, it means that the
preheating is finished.
9. Press down the pump control button"
10. After water has flown for 1 minute, press the pump control button "
water in each container then clean them thoroughly, now you can start brewing coffee.
Note: There may be noise when pumping the water for the first time, it is normal, as the appliance is
releasing the air in the appliance. After about 20s, the noise will disappear.
PREHEATING
To make a cup of good hot Espresso coffee, it is recommended to preheat the appliance
before making coffee, including the funnel and cup, so that the coffee flavor will not be
influenced by the cold parts.
1. Remove the removable water tank and fill it with desired water, the water level should be
between the "MAX" mark and the "MIN" mark in the tank. Then insert the tank into the appliance
properly.
2. Set steel mesh into metal funnel (no coffee in steel mesh), then put the metal funnel under the
metal funnel holder (see Fig.1), and turn it anticlockwise until it is fixed tightly (see Fig.2 and Fig.3).
3. Place an espresso cup you have prepared on removable cup shelf.
4. Then connect the appliance into power supply. Make sure the steam knob is at the "O" position.
5. Press the ON/OFF button "
sure the coffee/steam button"
6. Press down the pump control button"
close the pump immediately by pressing the pump control button"
The purpose of the step is to pump the water of the tank into the housing.
7. When the coffee indicator (green) is illuminated, and you should press down the pump control
button "
" again, there will be hot water flowing out.
8. After water has flown for 20S, press the pump control button"

MAKE ESPRESSO COFFEE

1. Remove the funnel by turning it clockwise.
2. Add ground coffee to steel mesh with measuring spoon, a spoon ground coffee power can make
about a cup of top-grade coffee, then press the ground coffee powder tightly with the tamper.
", the pump will pump water, when there is water
"/ "
" is at the higher position and wait for a moment, the
" again, and water will flow out.
" to turn on the unit, the power indicator (red) will illuminate, make
"
" " is at the higher position.
/
" to the lower position, when there is water flowing out,
18
" to turn on the unit. The power
" again.
", you can pour out the
" again to the higher position.
". The preheating is finished.

Publicité

Table des Matières
loading

Table des Matières