Increasing The Lighton Sensors Sensitivity - Dreamzon Lighton Manuel D'utilisation

Increasing the Sensitivity of LightOn Sensors
The LightOn device works by converting the vibration
signals of your cell phone into a flashing LED light. If your
LightOn device is not able to recognize your cell phone's
vibration signals (because the vibration is weak or short),
it is possible to increase the sensitivity of LightOn's
sensors.
How to Modify Sensor Sensitivity?
1. Insert three AA batteries into the battery compartment.
All the LED lights flash brightly, followed by the
intermittent flashing of the left and right lights.
2. While the left and right LED lights are flashing, press the
Reset button.
3. The LED lights will stop flashing and a single LED light
will be lit on the upper right side of the cradle for a few
seconds. LightOn is now properly calibrated and ready
to be used.
Note: If you want to restore the default sensitivity settings
of LightOn's sensors, remove one of the batteries from
the battery compartment, hold the Reset button down
for a few seconds and then replace the battery in its
compartment.
Note: After changing the batteries, the LightOn device will
return to its default sensitivity settings. If you want to
restore the hi-sensitivity setting, repeat steps 1-3 above.
EN
11