Videx VR4KAM Manuel D'instructions page 2

4000 Series Vandal Resistant Line
Art. VR4KAM
Speaker unit for audio door entry systems "4+1" and video door entry systems
PROGRAMMING
The dip-switch and the jumper are accessible from the back of the module allowing the setup of the following parameters:
DIP-SWITCH 4 WAY
• The conversation time 1 or 2 minutes (switch 1);
• The door opening time 2,4,8 or 20seconds (switches 2,3);
• The recall on handset pick-up i.e. Speech live when a handset is lifted, no call required. (switch 4).
PROGRAMMING THE
CONVERSATION TIME
Switch Nr.1 Setting Up
ON
OFF = 2 minutes
1 2 3 4
ON
ON = 1 minute
1 2 3 4
JUMPER
Reassurance tone High, Low or off.
H
Reassurance tone enabled with high volume
L
H
Reassurance tone enabled with low volume
L
H
Reassurance tone disabled
L
NAME PLATE HOLDER AND LED MODULE INSTALLATION
NAME PLATE HOLDER INSTALLATION (FIG. 3)
1. Insert the name plate holder
2. Insert the name plate support
3. Insert the screws .
C
LED MODULE INSTALLATION (FIG. 4)
1. Remove the double-sided tape film
the LED module ;
E
2. By applying moderate pressure, make the LED module
here to the right inner of the box
ing) in correspondence to the central part of the module.
LED module electical features: 10/15vdc - 20mA.
Art. VR4KAM - Installation instructions
PROGRAMMING THE
DOOR OPENING TIME
Switch Nr.2
ON
OFF
1 2 3 4
ON
ON
1 2 3 4
ON
OFF
1 2 3 4
ON
ON
1 2 3 4
;
A
;
B
placed on the back of
D
(flush or surface mount-
F
Nr.3 Setting Up
OFF = 2 seconds
OFF = 4 seconds
ON = 8 seconds
ON = 20 seconds
Note: If the reassurance tone is enabled, the door opening is
also confirmed by a tone.
ad-
E
Fig. 3
- 2 -
RECALL ON HANDSET PICK-UP
Switch Nr.1 Setting Up
ON
OFF System recall disabled
1 2 3 4
ON
System recall by
ON
handset pick-up*
1 2 3 4
* The system recall by handset pick up
can be enabled only on one entrance
audio door entry systems.
A
B
C
Fig. 4
66250603 - V4.1 - 31/12/20
D
E
F