BOLERO DRESSCODE 7200 INVERTER Manuel D'instructions page 71

6. TROUBLESHOOTING
Problem
The washing
machine does
not start up
The door does
not open
Water leakage
Detergent
residues in the
box
Indicator or
display does not
light
Abnormal noise
Errors
Error Cause
E30 Door is not closed properly
E10 Water injecting problem while
washing
E21 Overtime water draining
E12 Water overflow
EXX Others
Cause
The door is not closed
properly
The safety lock system is
activated
Bad connection between
pipes and water supply hose
or drainpipe.
Detergent is dampened or
agglomerated
The power PC board is
disconnected, or harness has
connection problem
Solution
Restart after the door is closed.
Check if there are clothes stuck.
Unplug it and restart the product.
Check and fasten water pipes and
hose.
Clean up outlet hose.
Clean and wipe the detergent box
Check if the power is shut down and
the power plug is connected correctly.
Check if the fixing bolts have been
removed.
Make sure the appliance is installed
on a solid, level floor.
solution
Restart after the door is closed.
Check if there are clothes stuck.
Check if the water pressure is too low.
Straighten the water pipe.
Check if the inlet valve filter is blocked.
Check if the drainpipe is blocked.
Restart the appliance.
Contact the Technical Support Service of
Cecotec.
DRESSCODE 7200 / 8200 / 9200 / 10200 INVERTER
DRESSCODE 7200 / 8200 / 9200 / 10200 INVERTER STEEL
ENGLISH
71