Before First Use - Venta LW15 COMFORT Plus Mode D'emploi

OVERVIEW
1 Display
2 Upper housing
3 Switching power supply (assembled)
4 Transport protection

BEFORE FIRST USE

∙ Unpack and set up device. Remove the 50 ml bottle of hygiene additive 8 from
carton.
∙ Remove upper housing 2. Remove transport protection 4 from upper
housing 2.
∙ Remove disk stack 5 from lower housing 7 and transport protection 6.
COMMISSIONING
A C
A Fill lower housing 7 with tap water up to maximum WATERLINE marking
and add 50 ml hygiene additive 8 (complete content of bottle).
The device may never
be filled with the upper
housing in place!
Insert disk stack 5 in lower housing 7 and place upper housing 2 on lower
B
housing 7.
Connect mains plug of switching power supply 3 to the mains and switch
C
on device by briefly touching the power button in the display 1.
Only once the device is connected to the mains will the
i
power button  glow to switch the device on and off.
Image can be seen on fold-out page
5
6
7
8
Image can be seen on fold-out page
i
optimally humidified and cleaned.
Disk stack
Transport protection
Lower housing
Bottle of hygiene additive 50 ml
Adding the hygiene additive is
very important so that the air is
Venta Comfort EN 17
Plus