Horizon Global 76128 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Frame rail
Towhook
n
Figure 1
1. Lower exhaust - Remove the rubber isolators from the exhaust at the rear of the vehicle, (Figure 2) both sides. It may be necessary to remove the isolator forward
of the rear axle. Spraying a lubricant or soapy water on the metal hanger rod and the rubber isolator eases removal.
2. (For 2023 or newer) Remove center splash guard: Using 10 mm socket remove nuts from center splash guard. Using flat head screwdriver, remove rivets. Return
to vehicle owner.
3. Install hardware - Using the fish wire install items 1 and 2 as shown in figure 1 through the large access hole at the end of the vehicle frame. Repeat for both sides.
Note: Keep the fish wire attached to the hardware.
4. Install hitch - Gently raise hitch into position, carefully guiding the hitch over the mufflers. Feed the end of the fish wires through the attachment holes in the hitch,
be careful not to push the hardware back into the vehicle frame. Loosely install items 3 and 4 to hold the hitch in place. Conical washer teeth side against hitch.
Install item 5 through the bracket at the back of the hitch receiver and through the towhook, then loosely install items 6,7 & 8 onto item 5 as shown in Figure 1.
5. Tighten all 7/16" fasteners with torque wrench to 50 Lb.-Ft. (68 N*M) and 1/2" fasteners to 75Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
6. Raise exhaust – Raise the vehicle exhaust back into position and reinstall all isolators removed in step 1.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
© 2017, 2022 Horizon Global™ Corp. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76128, 84128, CQT76128
jk
o pq
lm
Figure 2
Access hole
Bolt Hole
Conical Washer
Fish Wire
Teeth side
Example
Against hitch
Sheet 3 of 9
Fastener Kit: 76128F
① Qty.(4) Carr. Bolt
7/16"-14 X 1 1/4" GR5
② Qty.(4) Spacer
3/16" x 1" x 2"
③ Qty.(4) Conical washer
7/16''
④ Qty.(4) Hex Nut
7/16"-14 GR2
⑤ Qty.(1) Carr. Bolt
1/2-13 X 2" GR5
⑥ Qty. (1) Spacer
1/4" x 1" x 3"
⑦ Qty. (1) Lock washer
1/2''
⑧ Qty. (1) Hex Nut
½"-13 GR5
⑨ Qty. (4) Fish wire
7/16"
76128N 10-28-22 Rev. B