Ionisation Function - SilverCrest SHTR 2200 D2 Mode D'emploi

_GRA270710_Haartrockner_B1.book Seite 37 Dienstag, 6. Oktober 2015 8:16 08

Ionisation function

You can use the ion switch 4 to additionally
activate the ionisation function, whatever
setting you are using. This then continuously
applies ions to the hair.
This reduces the static loading of the hair
and improves its stylability.
The hair becomes soft, smooth, glossy, and
easier to style.
• Ion function on, LED 7 lights up
• Ion function off, LED 7 off
Styling attachment
The styling attachment 12 makes it possible
to direct the air flow onto specific sections of
hair.
1. Place the styling attachment 12 onto
the front of the hair dryer, so that it
locks into position.
2. The styling attachment 12 can be rotat-
ed into any position desired.
3. Do not remove the styling attachment 12
from the hair dryer until it has cooled
down.
Curling attachment
With the curling attachment 14 you can eas-
ily create curls and waves. Since your hair is
exposed to significantly less heat, it is not
damaged as much as with a curling iron.
NOTE: the result is influenced by the follow-
ing factors:
- your hair type;
- the humidity of the hair;
- your hair length;
- the thickness of the strand of hair you
dry in one step;
- the pretreatment of the hair.
1. Wash your hair with regular shampoo.
NOTE: do not use any conditioner. It would
reduce the formation of curls.
2. Towel-dry your hair.
3. Brush the hair and ensure that all knots
are untangled.
4. Place the styling attachment 12 onto
the front of the hair dryer, so that it
locks into position.
5. Only dry the hair at the hairline.
6. Take off the styling attachment 12.
7. Place the curling attachment 14 onto
the front of the hair dryer, so that it
locks into position.
8. Separate your hair into individual
strands and treat each strand one by
one.
9. Figure A: slightly curl in a strand and
put it into the curling attachment 14
from above.
10. Select the highest temperature setting
and the highest speed setting on the
hair dryer . The strand of hair is
turned in the air flow of the curling at-
tachment.
11. Slowly move the hair dryer up and
down. The strand must be run through
the curling attachment from the hair
ends almost all the way to the hairline
until it is dry.
12. In order to stabilise the shape by
means of cool air press and hold the
button 10 during the last phase of
drying.
13. Proceed accordingly with the remain-
ing strands of hair.
14. Turn off the hair dryer and let the hair
cool off.
15. Then untwist the individual curled
strands.
16. Now you can continue styling your hair
as you would like. For example, you
can loosen the hair with your fingers or
brush it.
17. If you like, you can use hairspray to set
the style.
18. Do not remove the curling attachment|14
from the hair dryer until it has cooled
down.
37
GB