Castel MAYLIS MP Mode D'emploi page 8

MP
CONNECTION
The desktops are supplied with a 5 metre RJ45 8 pt cable and an RJ45 compatible junction box providing screw-
on connectivity.
Adaptation of the signalling line and the 0db line
Install a 120Ω resistor (supplied with the station) between the RS1 and RS2 points of the stations located at the end of
the bus line. If the bus line comprising one or more stations is connected to a central office, only the station located at
the end of the bus line furthest from the central office must be equipped with the resistor.
If only one station is connected to a central office line, jumper J15 must be installed in the station (installed by default).
The 0dB line is then monitored. A possible connection fault is then signaled.
Technical data sheet n° 600-0091E www.castel.fr
FR
EN
Page 8 / 12