Heston Blumenthal Everdure HBG2GUS Instructions De Montage page 16

Assembly, Operation & Maintenance Instructions
16
STEP 07
/ Position the stand with the castor wheels to the right. Two people should lift the barbeque
and hood assembly (01A) by the serveries, and place it within the stand (facing forwards,
castors to the right). Fix the barbeque to the stand top with the four M6x0.8in (20mm)
screws and 0.2in (6mm) flat washers removed at step 2 – two to the front and two to the
rear. Tighten fully.
STEP 08
/ To extend the left hand side servery, support the front of the barbeque and pull the
left hand servery forward (approximately 0.4in (1cm)) tensioning the spring. Rotate the
left hand servery to the vertical position and allow the tension in the spring to pull the
servery into place.
STEP 09
/ Fit the fat tray (12) and disposable foil tray into the brackets at the bottom of the
barbeque. Take care that the fat tray is allocated correctly.
*Due to ongoing design modifications, support brackets may be permanently fixed to the element