Heston Blumenthal Everdure HBG2GUS Instructions De Montage page 15

STEP 04
/ Take the two bottom shelf supports (06.07) and fit them onto the cylindrical tabs at
the inside of each foot. Rotate each one so that the outmost screw holes are facing
inwards and the inner screw holes are facing the stand top (if not, pull out and fit in
the opposite way). Take the two upper shelf supports (13.14) and fit them onto the legs
(03.04.05.06). Fix the bottom shelf support L (06) in place with two M6x0.6in (16mm)
screws (A). Fix the bottom shelf support R (07) in place with two M6x0.8in (20mm)
screws (j) and flat washers (E). When all are assembled, tighten up all four screws and
the screws from step 03.
STEP 05
/ Turn the stand onto its legs and check that all of the legs are stable. Take the plastic bottom
shelf (16) and place it on the two bottom shelf supports. Line the four holes in the bottom
shelf up with the threaded holes in the bottom tray supports and fix into position using four
M5x0.5in (12mm) screws (B) and four spring washers (C). Tighten fully. Take the plastic
upper shelf (17) and place it on the two upper shelf supports. Line the four holes in the
upper shelf up with the threaded holes in the upper tray supports and fix into position using
four M5x0.5in (12mm) screws (B) and four spring washers (C). Tighten fully.
A
E
STEP 06
/ Take the cylinder belt (I) and fix into place using two M5x0.6in (15mm) screw (F). The gas
cylinder can be put onto the bottom shelf support R (07) and fix in place by cylinder belt (I)
Tighten it by adjusting the cylinder belt (I).
Assembly, Operation & Maintenance Instructions
15