General Information - FERMOD 2320 Notice D'instructions

1 – GENERAL INFORMATION
1.1. Regulations & Obligations
The product you have acquired is integrated into an industrial door. Its being put on the European Union
and/or Great Britain market implies EC and/or UKCA marking by a certified agency, under the liabilities of
the manufacturer and/or installer of the door.
The design, manufacture and installation of an industrial door must respect the essential requirements of
health and safety determined by the following European/UKCA directives:
The proof of conformity to the regulation texts, mentioned above, is obtained by the respect of the standard reference
detailed by the standard of product NF EN 13241-1. - Industrial, Commercial and Garage Doors (Part 1: products
without fire and smoke proofing characteristics)
Terminology standard Safety standard Environmental standard
EN 12433-1
Types of doors
EN 12433-2
Components of doors
FERMOD has taken the standards that apply to the supplied products into consideration.
1.2 - Liabilities
1 - The manufacturer of the door, the installer and the user must observe the safety rules (collective protection,
individual protection) applicable during transport, assembly, use, and discarding of the door or its components
EN 12604
Mechanical aspects Resistance to wind
EN 12605
Test methods Tests and calculations
EN 12453
Safety of use Water penetration
EN 12445
Test methods
EN 12978
Safety devices Permeability to air
EN 12635
Installation and use
Thermal transmission
Electrical and standard
EN 12424
EN 12444
Immunity to industrial environment
EN12425
Harmonic measure emission
EN 12489
Test methods Industrial environment emission
EN 12426
EN 12427
Test methods
EN 12428
- 5 -
EN 60204-1
Machine electrical safety
EN 61000-6-2
EN 61000-6-3
EN 61000-6-4
NMPOIG.FIXE/F