Maintenance; Service Information; Technical Data - OHAUS PX Serie Mode D'emploi

EN-6
4.2 Principal Functions
Zeroing:
Taring:
Weighing:
Dot-matrix
Display:

5. MAINTENANCE

5.1 Cleaning
WARNING: Disconnect the balance from the power supply before cleaning.
Make sure that no liquid enters the interior of the balance.
Clean the balance at regular intervals.
Housing surfaces may be cleaned with a lint-free cloth slightly dampened
with water or a mild cleaning agent.
Glass surfaces may be cleaned with a commercial glass cleaner.
Attention: Do not use solvents, harsh chemicals, ammonia or abrasive cleaning agents.

5.2 Service Information

For troubleshooting common problems, download the user manual from www.Ohaus.com.
If the issue persists, please visit our website for available support and service centers at
https://www.ohaus.com/en-us/support/service-centers.

6. TECHNICAL DATA

The technical data is valid under the following conditions:
Indoor use only

Altitude: Up to 2000 m

Operating temperature: 5°C to 40°C

Operating temperature for optimum weighing performance: 10°C to 30°C

Humidity: maximum relative humidity 80% for temperatures up to 30°C,

decreasing linearly to 50% relative humidity at 40°C
Electrical supply: 12VDC, 0.5A. (For use with certified or approved power

supply, which must have a SELV and limited energy output.)
Mains supply voltage fluctuations: up to ±10% of the nominal voltage

Installation category II

Pollution degree: 2

Detailed product specifications can be found in the user manual and can be
downloaded from www.Ohaus.com/products.
Press Zero to zero the balance.
With no load on the pan, press
an empty container on the pan and press Tare. Add material to the
container and its net weight is displayed. After the container and the
objects are removed, the tare value will be displayed as a negative
number. Press Tare to clear.
First press Zero to set the display to zero. Place an object on the
pan. The display indicates the gross weight.
The relevant data in the specific application mode are shown in the
dot-matrix display area.
Zero
to set the display to zero. Place