Hella 2JA 959 073-00 Serie Instructions De Montage

Fitting Instructions for
White Interior
Part Number: 2JA 959 073-00x / 2JA 959 076-50x - Clear Lens 12V
2JA 959 073-20x / 2JA 959 076-60x - Clear Lens 24V
Included in the kit is:
2 Black Stainless Steel Screws
2 Cable Connectors
1.0 MOUNTING
Determine mounting position and holes as per the diagram below (before fitment see
2.0 WIRING).
Fit lamp to mounting aperture with the screws provided.
Fit screw caps.
Note:
Do not overtighten mounting screws in lens.
If it is necessary to remove the screw caps, lever them out with a pin.
General Dimensions (mm)
LED
Lamp
4 Screw Caps (2 x Black & 2 x Clear)
1 Lamp with 2.5 Metre Cable
959 149-22 / 06.18
2.0 WIRING
Due to the advanced LED technology employed in the manufacture of this White Interior LED Lamp, some
additional care must be taken while wiring this unit.
The LED Lamp is polarity conscious, that is, unless the lamp is correctly connected it will not function. The
RED cable must be connected to POSITIVE (+).
As almost all circuit applications are Negative Earth, we have written these instructions to suit.
Disconnect battery NEGATIVE (-) terminal. Run cable to existing wiring harness, if possible where other
cables already run. Make sure that the cable insulation is not damaged by sharp edges.
Connect the RED cable to the existing cable POSITIVE (+), and the BLACK cable to a suitable earth
NEGATIVE (-).
This is quite simple with the snap-lock connectors provided.
Fit snap-lock connector over existing cable so that the cable fits in the rear tubular groove. Insert LED Lamp
cable b into the front tubular groove. Do not allow the cable end to hang out of the connector c.
e
Press the metal tab on the snap-lock connector firmly in with pliers d. Fold the plastic flap e over the body
of the snap-lock connector until it clicks into position.
Reconnect battery NEGATIVE (-) terminal.
Wire Colour Connect to
Red Positive (+)
Black Negative (-)
Notes: - lamp must be protected by a fuse rated at 2 amperes maximum.
- applied voltage above the following limits will damage the internal LED's:
12V lamp - 16V continuous & 24V lamp - 30V continuous
FIT AND FORGET - BY DESIGN
Congratulations, the product you have selected comes from HELLA - a world leader in
LED lighting design.
Following the launch of the first LED automotive signal lamps in 1990, HELLA Design
and Innovation continues to set new standards. HELLA innovative solutions have
been incorporated into millions of lamps, engineered and tested to the most stringent
standards, to suit the most demanding environmental conditions.
The cornerstone to the success of our products is our no compromise Fit and Forget - by Design
philosophy which is incorporated into every step of the product life cycle.
In a world consuming finite resources at an ever faster rate, Fit and Forget - by Design is the right
environmental choice that also makes perfect economic sense to customers that consider the total life cycle
Cost of Ownership
For general comments about HELLA's products please contact us on E-mail at techfeedback@hella.co.nz
d
Power Consumption
Less than 2 watts
-