ATH-Heinl Single Lift 25M Manuel D'utilisation page 76

Install The Control Panel
Install the control panel onto the column as shown in the following Diagram:
Electric control assembly
Fit the electric control to the column using the supplied screws as shown in the adjacent diagram.
Check the nameplate to ensure that the motor is suitable for the voltage available at the customer's
premises.
Establish the electrical connections as shown in the circuit diagram (point 6.2). Use the cables and
lines supplied for this purpose.
Work must be carried out in accordance with local regulations. Make sure that the phases are properly
connected (direction of rotation) and
the lift is properly grounded.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-09
Screw M6x20
Manufacturer ATH-Heinl GmbH & CO.KG
- 23 -