Publicité
Les langues disponibles
Les langues disponibles
11. DIP-SWITCH setup
On the back side of the card there is a DIP-SWITCH that allows to enable / disable the buzzer and the backlighting of the
keyboard.
It is suggested to enable the buzzer during the setup operation.
DIP SWITCH 1
On: backlighting ENABLED
Off: backlighting DISABLED
In case of battery supply, once the programming is terminated it is suggested to turn both the dip-switch OFF in order to
improve the efficiency and increase the lifetime of the battery.
12 Device Total Reset
1
Keep reset key pressed
2
Beep emitted by the keyboard
3
Two Beeps emitted by the keyboard
4
Three Beeps emitted by the keyboard
5
The keyboard keeps on Beeping
Total Reset terminated
6
ATTENTION: IN CASE OF TOTAL RESET ALL THE USERS ARE DELETED, THE MASTER CODE (SEE
PARAGRAPH 3) AND ALL THE SETTINGS RETURN TO BE THOSE SET BY THE FACTORY.
6-1622368
REV.2
26/06/2014
ON
DIP SWITCH 2
On: Buzzer ENABLED
Off: Buzzer DISABLED
2
1
DO NOT release the key
DO NOT release the key
DO NOT release the key
Release the key
ITA
ENG
FRA
ESP
DEU
POR
7 /12
Publicité
