Filling The Water Tank; Setting The Temperature - Girmi ST62 Manuel D'utilisation

The iron must be used and rested on a stable surface.
When placing the iron on its iron stand, make sure that
the surface is stable. The iron should not be used if
dropped, when there are visible signs of damage, or if it
loses water during operations.
CAUTION: the iron plate gets very hot during use,
be careful not to touch it, serious risk of burns.
Do not put your face near the steam coming out the
iron plate.
(1) Water spray hole
(4) Steam shot button
(7) 360° rotating cable
(10) Self-clean button
(12) Base
FILLING THE TANK
The filling operation must be performed only when the plate has been cooled down and after having
unplugged the unit from the electrical outlet. We recommend the use of demineralized water to prevent
excessive fouling (not covered by warranty).
Place the steam control knob (3) on "0". Open the water tank lid (2).
1)
2) Raise the tip of the iron to avoid any leak of water during the operation.
3) Enter the water up to the maximum level (380ml) indicated with "MAX" on the tank. Close the lid (2).
TEMPERATURE SETTING
The following table provides a guideline on how to adjust the thermostat according to the international
symbols printed on the clothing labels or according to the type of fabric.
• It is recommended ironing clothes that require low temperatures first and then medium and high
temperatures. This operation allows to save time since ironing plate heats faster than it cools down.
• When you do not know the composition, it is recommended to iron a non-visible part of the it, starting from
the lowest temperature to find the most suitable temperature.
• Sometimes the clothing becomes shiny, in this case you need to iron it on the inside not to ruin it. When
ironing at maximum temperature (MAX), it is recommended to place a cloth between the ironing plate and
the fabric.
MOD. ST62
(2) Water tank lid
(5) Water spray button
(8) Handle
(11) Stainless steel iron plate with micro holes
(13) Water tank
LABEL FABRIC
Synthetic
(Acrylic, nylon...)
silk – wool
cotton – linen
(3) Steam regulator
(6) Iron plate control light
(9) Temperature control knob
TEMPERATURE
·
Low temperature
··
Medium temperature
···
High temperature
Do not iron
12