Kenwood Peek & View TTM040 Serie Manuel D'instructions page 3

key
removable warming rack/toast rack
warming rack handle
Peek & View™ carriage lever
(with 'Hi-Rise™' for extra lift)
browning control
cancel button with indicator light
crumb tray
cord storage
to use your toaster
Your toaster can toast up to four slices
of bread at one time and has been
designed so that the two left hand slots
can be controlled independently of the
two right hand slots.
1 Plug the toaster into the power
supply.
2 Move the browning control to the
desired setting. Use a low setting
for light toasting and for thin or dry
bread.
3 Insert the bread, muffins, bagels etc.
4 Lower the lever
'cancel' button will illuminate. (The
lever will not stay down unless the
toaster is plugged in).
To toast frozen bread, move the
●
browning control to the defrost
position .
Use the carriage lever to lift the toast
●
to Peek & View™ at any time
without cancelling the toasting cycle.
To stop toasting during the cycle,
●
press the 'cancel' button, the toast
will pop up and the 'cancel' button
light will go off.
5 Your toast will pop up
automatically, to raise it higher, lift
the lever.
hints on using your
toaster
Select a lower setting for light
●
browning, for toasting one slice only
or for dry bread.
When toasting a single slice of
●
bread, you may notice a variation in
toast colour from one side to the
other - this is normal.
until it locks. The
Dry/stale bread toasts more quickly
●
than fresh bread and thinly sliced
bread toasts more quickly than
thickly sliced bread. Therefore the
browning control should be set at a
lower setting than usual.
For best results ensure that the
●
bread slices are of an even
thickness, freshness and size.
In order to achieve uniform browning
●
we recommend you wait a minimum
of 30 seconds between each
toasting so that the control can
automatically reset. Alternatively
select a lower setting when
additional toasting is carried out.
warming rack safety
1 Never set the browning control
higher than
warming rack.
2 Never completely cover the warming
rack.
3 When using the warming rack, never
wrap the food up. Plastic wrapping
will melt and could catch fire. Foil will
reflect heat, damaging the toaster.
4 If you're using the toaster slots,
always remove the warming rack so
it can't burn you.
to use the warming rack
1 Place the warming rack on top of
toaster . It must be fitted either
over the two left hand slots or two
right hand slots, never in the middle.
2 Put your food on top of the rack
(slicing thick items in half will speed
up the warming process).
3 Set the browning control no higher
than
. Lower the lever.
4 The lever will automatically rise at the
end of the warming cycle. Turn the
items over and repeat the operation.
Watch to make sure they don't burn.
5 To remove the warming rack, allow
the toaster to cool and unplug. Lift
off the warming rack.
3
when using the