Télécharger Imprimer la page
Les langues disponibles
  • FR

Les langues disponibles

Liens rapides

VDP250MH6 – PROFESSIONAL 6-CHANNEL MOVING HEAD
1. Introduction & Features
Thank you for buying the VDP250MH6 ! Please read the manual carefully before bringing this
device into service.
This device is equipped with 6 DMX channels and can be controlled by any DMX512 device e.g.
LPTCX5.
Make sure there is no damage caused by transportation. Should there be any, consult your
dealer and don't install this device.
2. Safety Instructions
Be very careful during the installation : touching live
wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up
Keep this device away from rain and moisture
Unplug the mains lead before opening the housing
• A qualified technician should install and service this device.
• Damage caused by disregarding certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for the ensuing defects or problems.
• Do not switch the device on immediately if it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device falls under protection class I. It is essential, therefore, that the device be earthed.
Have this device installed by a qualified technician.
• Make sure that the available voltage does not exceed the voltage stated in the specifications
of this manual.
• Do not crimp the power cord and protect it against damage from sharp edges. Ask an
authorised dealer to replace the cord if necessary.
• Always disconnect the device from the mains when it is not in use or when you wish to clean
it. Only handle the power cord by the plug. Never pull out the plug by tugging the power cord.
• There may be some smoke or a particular smell when the device is activated for the first
time. This is normal and the smell will gradually disappear.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they
do.
• Note that damage caused by user modifications to the device are not covered by the
warranty. Keep the device away from children and unauthorised users.
VDP250MH6
1
VELLEMAN
loading

Sommaire des Matières pour HQ Power VDP250MH6

  • Page 10: Vdp250Mh6 - Lyre A 6 Canaux

    • Ne regardez pas directement la source lumineuse, comme ceci peut occasionner des crises d'épilepsie chez certains gens. • Les dommages occasionnés par des modifications à l'appareil du côté du client ne tombent pas sous la garantie. Tenez votre VDP250MH6 à l'écart de personnes non qualifiées et de jeunes enfants. VDP250MH6...
  • Page 11 • Transportez l'appareil dans son emballage d'origine. • Pour des raisons de sécurité il est interdit de modifier l'appareil. • Employez le VDP250MH6 uniquement pour les applications décrites dans ce manuel afin d'éviter les courts-circuits, les brûlures, les électrochocs, etc. Un usage interdit peut occasionner des dommages et annule d'office la garantie.
  • Page 12 • Fixez votre VDP250MH6 à l’aide d’un câble de sécurité (sécurité additionnelle). • Evitez de vous positionner en dessous du VDP250MH6 pour l’enlever ou lors du montage ou nettoyage de l’appareil. Un technicien qualifié doit réviser l’appareil avant la mise en service.
  • Page 13 La LED à côté des interrupteurs DIP indique le statut du signal DMX. La LED clignote quand le signal DMX est employé. La LED est allumée continuellement quand le signal DMX n’est pas reconnu et la LED reste éteinte s’il n’y pas de signal d’entrée DMX. VDP250MH6 VELLEMAN...
  • Page 14: Vdp250Mh6 - Proyector "Moving Head" De 6 Canales

    VDP250MH6 – PROYECTOR "MOVING HEAD" DE 6 CANALES 1. Introducción y características ¡Gracias por haber comprado el VDP250MH6! Lea cuidadosamente las instrucciones del manual antes de usarlo. Este aparato está equipado de 6 canales DMX y se puede controlar por cualquier aparato con control DMX512 p.