ledscom LC-EL-143-WW Mode D'emploi page 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2. Remove the light from the mounting pot
(Figure 1).
3. Punch or cut a cable hole in the
installation pot at one of the perforations
provided (Figure 2).
4. Lead either the building-side connection
cable (Figure 3) or that of the luminaire
(Figure 4) through the opening just
created. Make sure that you have enough
space in the installation pot afterwards to
store the cables and the connector.
5. Connect the connection cable of the
luminaire to the connection cable on the
building side. The cables must be
connected in a watertight manner (e.g. with
a cable sleeve).
6. Now place the luminaire in the mounting
pot and place it in the designated location.
7. Turn the power back on. The installation
is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
Figure 3
Paving stone (LC-EL-143-WW) - Assembly instructions
Figure 2
Figure 4
01/2023