Publicité
Les langues disponibles
Les langues disponibles
S.P.E. Elettronica Industriale
When the maximum voltage admissible for a specific battery is reached (value given by the
manufacturer) the error message 'E01' is displayed, and the process is terminated.
By using an internal thermostat, the charging can be interrupted in case of excessive battery
charger over-temperature. In this case the error message 'E02' is displayed.
Possibility of setting each single charging phase. On exceeding this time, the charge will be in-
terrupted and the error message 'E03' will be displayed.
The display of the message 'SCt' indicates safety timer operation.
The message 'Srt' will be displayed in case of internal short circuit.
Authorized Service Centers can change the battery voltage and the charging current always by
means of a DIP-switch. On the control card placed behind the front panel of the battery charger
eight DIP- switches are available for:
1. Selecting the charging curve: DIP1 DIP2 DIP3 DIP4.
2. Selecting the fast charging current I1 (current of the first charging phase): DIP5 DIP6
3. Selecting the battery voltage: DIP7 DIP8
The set of eight DIP-switches is easy to access without opening the charger but only lifting up the
left corner of the front panel of the charger.
Programming of battery charger is possible by changing dipswitch configuration. According to the
charging curve, charging current and battery voltage requested, it is necessary to set the position
of each dipswitch either in the "ON" or the "OFF" position in compliance with the selection scheme
shown at the following page.
Technical Department – Research & Development
TECHNICAL REMARKS
2
Publicité
