BEA IXIO-DT1 V Manuel D'instructions page 9

TECHNICAL SPECIFICATIONS (CAMERA)
Voltage regulator
(built into wire harness):
Operating temperature:
Video output:
Image Sensor:
Horizontal resolution:
NTSC output:
Sync system:
BEA, the sensor manufacturer, cannot be held responsible for incorrect installations or inappropriate adjustments of the sensor/device; therefore, BEA
does not guarantee any use of the sensor outside of its intended purpose.
BEA strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and factory-
trained for the type of door/gate system.
Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor
system installation is compliant with local, national, and international regulations, codes, and standards.
Once installation or service work is complete, a safety inspection of the door/gate shall be performed per the door/gate manufacturer recommendations
and/or per AAADM/ANSI/DASMA guidelines (where applicable) for best industry practices. Safety inspections must be performed during each service
call – examples of these safety inspections can be found on an AAADM safety information label (e.g. ANSI/DASMA 102, ANSI/DASMA 107, UL 325).
Verify that all appropriate industry signage and warning labels are in place.
BEA hereby declares that the IXIO-DT1 is in conformity with the basic requirements and the other relevant provisions
of the directives 1999/5/EC, 2006/95/EC and 2006/42/EC.
Notified Body for EC-type inspection: 0044 - TÜV NORD CERT GmbH, Langemarckstr. 20, D-45141 Essen
EC-type examination certificate number: 44 205 12 405836-001
Angleur, October 2014 Pierre Gardier, authorized representative and responsible for technical documentation
The complete declaration of conformity is available on our website: www.bea-pedestrian.be
Only for EC countries: According to the European Guideline 2012/19/EU for Waste Electrical and Electronic Equipment (WEEE)
General Tech Questions: Tech_Services@beainc.com | Tech Docs: www.BEAinc.com
Page 9 of 9
6.6 – 36 VDC (±10%)
6 – 28 VAC (±10%)
-30 – 60 °C (max. RH: 95%)
1.0 (Vp-p) / 75Ω
CMOS
480 TVL
720 (H) × 480 (V)
Inter-Sync
BEA INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS
Tech Support: 1-800-407-4545 | Customer Service: 1-800-523-2462
Frame rate:
Minimum illumination:
AE control:
Gain control:
Electronic shutter:
S/N ratio:
AWB:
75.5816.09 IXIO-DT1 V UL 20180305
30 fps
0.01 LUX
auto
auto
1 s ~ 1/10,000s
> 50 dB
Auto