File Transfer - Nicols C 512 J II Notice D'utilisation

 Manual Mode
When the power is turned on, the unit enters manual mode automatically.
-
Check and verify that both the Auto and Music LEDs are off.
-
Use the Bank Up/Down button to select the bank with the scenes you wish to run.
-
Press the scene button corresponding to the scene you wish to display.
-
 Auto Mode
This function allows you to run a bank of programmed scenes in sequence.
Press the Auto/Del button to enter into Auto mode. The Auto LED will light indicating the Auto mode is active.
-
Use the bank Up/Down button to select a bank of scenes to run.
-
After selecting the bank of scenes to run, you can use the speed slider and Fade Time slider to adjust the speed of
-
the scene progression.
You can use the Tap Sync/Display button to set the speed instead. The amount of time between the last two taps will
-
instruct the controller in the length of time between steps. This setting will stay in effect until the speed slider is
moved.
Press the Auto/Display button to exit Auto mode.
-
Music Mode

Press the Music/Bank Copy button to activate Music mode.
-
Use the bank Up/Down button to select a bank of scenes you wish to run. The scenes selected will run through
-
sequentially to the beat of the music identified by the built-in microphone.
Tap the Music/Bank Copy button again to exit music mode.
-
Running Chases

 Manual Mode
When the power is turned on, the unit enters manual mode automatically.
-
Select the chase you wish to run by pressing the corresponding chase button. Pressing this button a second time will
-
unselect the chase.
Auto Mode

Press the Auto/Del button to activate Auto mode.
-
Select the desired by pressing one of six Chase buttons. Pressing this button a second time will negate this selection.
-
Use the speed slider and Fand time slider to adjust the chase to your specifications.
-
Music Mode

Press the Music/Bank Copy button to activate Music mode.
-
Select the desired chase by pressing one of six Chase buttons, this will activate the chase and cause it to respond to
-
the rhythms of the music.
File Transfer allows the user to transfer all information stored in one C 512 J II to a second C 512 J II unit. You must connect the
units using 3-pin XLR cables. The unit sending the information will have the cable plugged into the DMX "Out" plug, and the
receiving the information will have the cable running into the DMX "In" location.
 To Send A File Dump
With the power off to the unit, press and hold down the scanner 2 and 3 buttons and scene 1 button at the same
-
time.
Turn the unit back on while pressing these three buttons, the LCD will read "TRANSMIT" indicating that the unit is
-
ready to send the files.
Press scene button 7 and 8 at the same time to send the file dump.
-
If an error occurs during the file dump, the LCD will readout "ERROR".
-

FILE TRANSFER

Page 18