Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Enable Programming Mode.
-
Tap the Chase button to select the chase you wish to program.
-
Select a desired scene from the bank that has scenes stored inside it.
-
Tap the MIDI/Rec button.
-
Repeat steps 3-4 until all desired scenes scenes have been entered.
-
Inserting a bank of scenes into a chase
Enable Programming Mode.
-
Select the chase you wish to program.
-
Use the Bank Up/Down key to select the bank of scenes you wish to copy.
-
Tap the Music/Bank Copy button.
-
Tap the MIDI/Rec copy button, all LEDs will flash three times indicating that the requested operation has been
-
performed.
Add A Step
Enable Programming Mode.
-
Press the corresponding button to the chase you wish to add a step to.
-
Press the Tap/Display button, the LCD will show the current step.
-
Press the Bank Up/Down button and scroll to the step you wish to insert the step after.
-
Press the MIDI/Rec button, the segment display will read the step one step higher than before.
-
Tap the Tap/Display buttonagain. The LCD shows the current chase, scene, and bank. Create a desired scene and
-
record it as a new step or select a previously programmed scene to add to the chase.
Once you have selected the scene you wish to add, press the MIDI/Rec button again. All LEDs will flash three time
-
indicating the new step has been inserted into the chase.
Deleting A Step
Enable Programming Mode.
-
Select the chase that contains the step you wish to delete.
-
Press the Tap/Display button, the LCD shows the current step.
-
Press the Bank Up/Down button and scroll to the step you wish to delect.
-
Press the Auto/Del button to delete the step. All LEDs will flash three times indicating the requested operation has
-
been performed.
Delete A Chase
Press the button corresponding to the chase you wish to delete.
-
Press and hold down the Auto/Del button while holding down the chase button. All LEDs will flash three time
-
indicating that the requested operation has been performed.
Delete All Chases
With the power off, press and hold down the Auto/Del and Bank Down buttons at the same time.
-
Reapply the power, and all chases should be cleared.
-
JOYSTICK/CHANNEL SELECTION
Set-up Joystick
Press and hold the "Program" button until LED is lit.
-
Press and hold the "Mode" and "Fine" buttons at the same time, the assign LED should light. If the reverse LED
-
lights, press "Fine" and "Mode" again to enter assign mode.
Use the bank Up and Down keys to select the axis you wish to assign (Pan or Tilt).
-
Use the "Tap/Display" button to select 16 or 8 channel mode.
-
Press the button corresponding to the scanner you wish to assign.
-
While holding the mode button press the scene number corresponding to the slider which controls the movement.
-
(Example: If pan is controlled by slider number 4, press and hold the "Mode" button while tapping scene button 4#).
When finished press the "Mode" and "Fine" button at the same time again to exit Assign mode.
-
Page 16
Publicité
Table des Matières
