Correct Disposal Of This Product - Andis reVITE MTC Mode D'emploi

blades by using a small brush or worn out toothbrush. To clean the blades we suggest to immerse
the blades only into a shallow pan of Andis Blade Care Plus, while the clipper is running. Any excess
hair and dirt that has accumulated between the blades should come out. After cleaning, turn your
clipper off and dry blades with a dry cloth and start clipping again.
If upon cleaning your blades you find that the blades will still not cut, there may be a few fine pieces
of hair trapped between the upper and lower blade. If this happens, you will need to snap the blade
off the clipper. Proceed to slide the upper blade to one side, without loosening the tension spring or
moving the upper blade completely out from under the tension spring (see Figure O for position of
blade). Wipe the surface between the blades clean with a dry cloth, then place a drop of clipper oil
where the upper and lower blades meet and also in the guide slot of the tension spring. Now slide
the upper blade to the opposite side of the lower blade and repeat this process. After completing
this procedure, slide the upper blade, centering it over the lower blade. Handle or store your Andis
clipper with the blades down so excess oil will not run into the clipper case.
USE GUIDELINES FOR LITHIUM-ION BATTERIES
1. The lithium-ion battery included with your clipper does not develop a "memory effect" like a
nickel-metal hydride (NiMH), or nickel cadmium (NiCd) battery. You can return the clipper to the
charger at any time for a full charge, or even use the battery before a charge cycle is complete.
Like most rechargeable batteries, lithium-ion batteries perform best when used frequently.
2. For maximum battery life, store the clipper in a partially discharged condition if the unit will be
unused for several months.
3. Avoid locating the clipper near heat vents, radiators, or in direct sunlight. Optimum charging will
result where the temperature is stable. Sudden increases in temperature can result in the battery
receiving less than a full charge.
4. Many factors influence lithium-ion battery life. A battery that has received heavy use or is more
than a year old may not give the same run-time performance as a new battery pack.
5. New lithium-ion batteries, unused for a period of time, may not accept a full charge. This is
normal and does not indicate a problem with the battery or charger. The battery will accept a full
charge after several cycles of clipper use and recharging.
6. Disconnect the charger or the clipper from the AC outlet if extended periods of non-use are
anticipated.
CARE AND SERVICING OF THE ELECTRICAL SYSTEM
Your clipper and adapter cord are an integrated electrical system. Good electrical contact must be
maintained for the motor to deliver full power and lithium-ion battery to charge properly. Limited or
erratic performance caused by dirt or age can be corrected in the majority of cases.
BLADE & CLIPPER/TRIMMER REPAIR SERVICE
When the blades of your Andis clipper/trimmer become dull after repeated use, it is advised to
purchase a new set of blades available through your Andis supplier. Some blade sets can be
resharpened - contact your Andis supplier or the Andis Company for information on resharpening.
If you wish your clipper/trimmer to be serviced as well, contact your Andis supplier. If you have a
problem contacting your Andis supplier contact the Andis Company customer service
department 1-262-884-2600 (USA) or email at info@andisco.com.
PROPER BATTERY DISPOSAL
The product you have purchased contains a rechargeable battery. The battery is recyclable. At the
end of its useful life, under various state and local laws, it may be illegal to dispose of this battery
into the municipal waste stream. Check with your local solid waste officials for details in your area for
recycling options or proper disposal.

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed with other household
wastes throughout the EU. To prevent possible harm to the environment or human health
from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of
material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for
environmental safe recycling.
CAUTION: Never handle your Andis clipper while you are operating a water faucet and never hold
your clipper under a water faucet or in water. There is danger of electrical shock and damage to
your clipper. ANDIS COMPANY will not be responsible in case of injury due to this
carelessness.
7