Makita DMR200 Manuel D'utilisation page 5

Cautions to the user
The changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
RF exposure statements
IMPORTANT NOTE: To comply with the FCC RF
exposure compliance requirements, the antenna(s)
used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction
with any other antenna or transmitter. No change to
the antenna or the device is permitted. Any change to
the antenna or the device could result in the device
exceeding the RF exposure requirements and void
user's authority to operate the device.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
For Canada:
Cautions to the user
The changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
RF exposure statements
To comply with the IC RF exposure compliance
requirements, the antenna(s) used for this transmitter
must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-
located or operating in conjunction with any other
antenna or transmitter. No change to the antenna or the
device is permitted. Any change to the antenna or the
device could result in the device exceeding the RF
exposure requirements and void user's authority to
operate the device.
This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation of the
device.
Explanation of general view (Fig.1)
Battery compartment locker
1.
Mobile (Cell phone) placing panel
2.
Play/Pause button
3.
Next track button/Fast-forward button
4.
Volume up button
5.
Volume down button
6.
Aux in indicator
7.
Volume max. or min. indicator/ Low battery indicator
8.
Bluetooth indicator
9.
Bluetooth pairing button
10.
Power button
11.
Previous track button/ Rewind button
12.
Speaker
13.
Handle
14.
DC in socket
15.
Auxiliary input socket
16.
USB charging socket
17.
Cable hole
18.
Mobile (Cell phone) storage cabinet
19.
14.4 V/18V battery terminal
20.
10.8 V battery terminal
21.
Battery cover
22.
Battery cartridge
23.
Button
24.
Mobile storage cabinet cover
25.
4