Folding/Unfolding Stage 2 - Evenflo ExerSaucer Triple Fun Manuel D'instructions

Folding/Unfolding Stage 2

A
B
B
C
D
F
F
E
F
E
G
1. To fold ExerSaucer ® , ALWAYS remove baby and toy
from ExerSaucer ® before folding.
A
bar
With ExerSaucer ® flat on the floor, twist each leg
assembly B fully clockwise (the direction of the arrow)
until it stops in the position shown.
B
Fully depress one of the pedestal locking tabs
B
push on the leg assembly ; leg will partially fold. Repeat
this procedure for all four legs.
After pressing the fourth pedestal locking tab
ExerSaucer ® will fold with the tray
D
rotating toward the
E F
base . Make sure all four tray locks
the base before trying to carry ExerSaucer ® .
F Note: Make sure the legs are at the same height
adjustment or the ExerSaucer ® will bind and not fold
properly (refer to page 8).
2. To unfold the ExerSaucer ® , release the four tray
F
locks by pulling them outward from the base
as shown.
Hold the base down with your foot, and pull the tray
upward. The tray will rotate as you pull and the legs will
lock in the upright position. The leg assemblies
G
lock onto the pedestals .
B
Twist the tray to make sure all legs are locked properly.
IMPORTANT: Make sure all four leg assemblies
G
firmly locked onto the pedestals G before use.
10
Stage 3
IMPORTANT: Child should not use the activity table if they can not stand up by themselves.
C then
C
, the
E
are locked onto
F
E
,
C
B will
B
are
Stage 3 is used for children who are walking age to 24 months.
A
C
1. Remove toys and seat from the ExerSaucer ® .
2. Follow Step 1 on page 10 to fold the ExerSaucer ® , but
do not let the tray lock to the base.
A
3. Place your fingers beneath the legs
push upward to disconnect the leg assemblies from the ped-
estals B . Repeat for all four leg assemblies.
B
4. After all four legs have been disconnected from the pedes-
tals, remove tray assembly
D
C
5. Turn tray C upside down and remove the large end cap
and the small end cap
G
C
11
Stage 3
B
A , as shown, and
C D
from the base .
E
F
from from beneath.
G
6. Squeeze both locking tabs on
each side of the tray to disconnect
C
and separate the tray halves .
Re-position them as shown.