Makita LXRM01 Manuel D'instructions page 5

Note:
To reset the system, you must put the radio in OFF
mode.
1. Press the Radio power button [
radio.
2. Press and hold both the preset button 3 [
Radio power button [
5 seconds. When the LCD shows a display of all the
icons, all the preset memories are back to factory
default.
Using flash light (Fig. 7)
WARNING:
To reduce the risk of injury, do not look directly into the
light when the work light is on.
Specifications
Power source
Tuning Frequency Range
Speaker
Output Power (18 V)
Operating time
(with radio output power 100 mW)
Dimension
(With Battery BL1430)
Net weight
Maintenance
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
All manuals and user guides at all-guides.com
] to turn off the
] and the
] for approximately
Model
LED
BL1415
BL1430
BL1815
BL1830
WARNING:
To reduce the risk of injury, DO NOT operate work light
without bezel assembly in place.
Using and adjusting the pivot head
Press the flash light button [
flashlight when the radio is either on or off.
Note:
The pivot head can pivot to a range of 150 degrees and
can be adjusted in 6 stages. Pivot head to desired
position. Allow the detent to snap into place.
Important:
Do not forcibly pivot the head.
LCD back light
Press any control buttons, LCD display will illuminate for
approx. 10 seconds.
LXRM01
D.C.14.4 V/18 V
1.4 W x 3
AM: 520-1,710 kHz
FM: 87.5-108 MHz
ø51 mm 8  3 W
3.0 W
Only Radio Only Light
11 hours 3.5 hours
25 hours 8.5 hours
11 hours 3.5 hours
25 hours 8.5 hours
263 mm x 75 mm x 196 mm (10-3/8" x 2-15/16" x 7-3/4")
0.95 kg (2.1 lbs) (with battery BL1415)
1.14 kg (2.5 lbs) (with battery BL1430)
1.01 kg (2.2 lbs) (with battery BL1815)
1.23 kg (2.7 lbs) (with battery BL1830)
] to switch on/off the
Radio/Light
2.5 hours
6 hours
2.5 hours
6 hours
5