ledscom LC-L-186-WW Mode D'emploi page 5

1. Disconnect the building-side connecting
cable from the power supply and secure it
against being switched on again. To do
this, trip the corresponding circuit breaker
of the house installation.
2a. Mounting with mounting plate (Figure
1):
1. Screw the mounting plates (1) directly
onto the mounting base (soft, non-brittle
material, for example wood) using the
enclosed screws (2).
2. Then place the light on the mounting
plates (1) with slight pressure until they
snap into place.
2b. Mounting with double-sided adhesive
tape (Figure 2):
1. Clean the mounting base. It should then
be free of dust, grease and moisture.
2. First remove one backing film from each
of the two double-sided adhesive tape
strips (3) and stick them to the luminaire.
Then remove the other backing film and
stick the luminaire to the mounting base.
3. Connect the light to a compatible power
supply or interconnect cable as shown in
Figure 3. The installation is now complete.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English Under-cabinet light (LC-L-186-WW) - Assembly instructions
Figure 1
Figure 2
Figure 3
1: Mounting plate
2: Screws
3: double-sided adhesive tape
01/2023