Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Make sure power drive is unplugged from power source before changing the roll sets or remo-
ving the roll groover.
To remove or install the Roll
1.
Remove E-Ring that holds pivot pin. (Fig 6)
2.
Push pivot pin back until stops.
3.
Loosen depth adjustment screw.
4.
Take out the pivot pin.
5.
Raise up groove roll housing. (Fig 7)
6.
Loosen set screw that holds groove roll shaft. (Fig 8)
7.
Remove groove-roll shaft and groove roll.
8.
Install proper groove roll in groove roll housing. Section of the groove roll that forms the groove
goes towards the main housing.
9.
When tightening set screw make sure it mates with drill point in shaft.
10. Re-install roll housing.
ROLL SET REMOVE AND INSTALL
Fig.6
Fig.7
21
Publicité
Table des Matières
