Troubleshooting; Technical Data; Limited Warranty - GreenWorks Pro BPS60B00 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

all liquid and air are completely discharged through
the nozzle. Refill the tank with a few quarts of soapy
water (a mild dish detergent is recommended) and
discharge as previously instructed. If necessary, repeat
this procedure several times to ensure that the sprayer
is clean. Sporadic spray distribution is caused by a
clogged nozzle. If necessary, remove and clean nozzle.
Maintenance and storage
After use, the sprayer should be properly cleaned and
stored away from direct sunlight to prevent UV damage.
Before storing for the winter, be sure that all liquid is
completely drained from the tank, lines and air chamber.
(Refer to the CLEANING AND MAINTAINING THE
SPRAYER instructions above). Regularly inspect hose,
pump tank for water, damage or leaks.
10

TROUBLESHOOTING

PROBLEM
POSSIBLE
CAUSE
Liquid leaks.
Nut may be
loose or rubber
seal is cracked
or damaged.
Liquid leaks
Lid not
from the lid.
screwed on
tightly or seal is
cracked or
damaged.
Tank starts to
Vent holes in
collapse; tank
tank lid have
lid cannot be
become clog-
unscrewed
ged.
creating vac-
uum.
Low or no
Battery is out
pressure.
of charge,
switch is in "off"
position or tip
nozzle is stuck.
Tank leaks at
Seals are dam-
pump connec-
aged.
tion.
Tank leaks at
The hose
pump.
clamp is loose.
Tank leaks at
Clamp is loose
hose connec-
or damaged.
tion.
Diaphragm is
Diaphragm is
leaking.
damaged.
English
SOLUTION
Tighten the nut
and/or replace the
seal and lubricate.
Tighten lid. Lubricate
the seal, replace if
necessary.
Remove cap and with
a small wire, unclog
the holes. Clean the
cap, check the valve.
Lubricate check valve
and reinstall.
Charge the battery
to full charge, turn
switch to ON posi-
tion, unscrew nozzle,
and remove debris.
Replace damaged
seals
Tighten the hose
clamp.
Tighten clamp or re-
place if damaged.
Replace diaphragm.
11
PROBLEM
POSSIBLE
CAUSE
The battery is
not charged.
Battery is too
cold.
The machine
does not start.
11

TECHNICAL DATA

Rated Voltage
60V; Cordless, battery pow-
ered
Max. Pounds Per
70 PSI (0.5 MPA)
Square Inch Pressure
Rated Gallons Per
0.5 GPM (1.89 L/min)
Minute
Maximum Inlet Water
104 °F (40 °C)
Temperature
Cleaning Units
35 C.U.
Capacity
4 Gallons
Weight (without bat-
11.69 lbs. (5,3 kg)
tery pack)
Battery Mode
LB602 and other BAC series
Charge Mode
CAC801 and other CAC series
12

LIMITED WARRANTY

GARANTIE OUTIL &
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
Greenworks hereby warranties this product, to the
original purchaser with proof of purchase, for a period
of four (4) years against defects in materials, parts
or workmanship. Greenworks, at its own discretion, will
repair or replace any and all parts found to be defective,
through normal use, free of charge to the customer.
This warranty is valid only for units which have been
used for personal use that have not been purchased
SOLUTION
Charge the battery
by following the pro-
cedures in the battery
and charger manual.
Remove battery from
backpack sprayer.
Place battery on
charger and allow
to charge for 10 mi-
nutes or until the
changing light turns
green. Remove from
charger and install in
backpack sprayer for
use.
EN

Publicité

Table des Matières
loading

Table des Matières