Overhead Rigging - JB Systems Light LED ClubScan Mode D'emploi

ENGLISH
DESCRIPTION:
1. Hanging bracket with 2 knobs to fasten the unit and a mounting hole to fix a mounting hook.
2. DIP switches, used to set the DMX-starting address of the unit.
3. Optical lens with manual focus adjustment.
4. Scanning mirror.
5. Cooling system: used to cool the components inside the enclosure. Make sure to never cover this fan
outlet!
6. ¼" jack used to connect an optional CA-8 controller.
7. Din-5pin input, used to connect an optional wireless receiver, named RF-8R.
8. Microphone for the sound controlled functions
9. DMX input: 3pin male XLR-connector used to connect universal DMX-cables. This input receives
instructions from a DMX-controller or from another LED CLUBSCAN II light effect when used in
master/slave mode.
10. DMX output: 3pin female XLR-connector used to connect the LED CLUBSCAN II with the next unit in the
DMX chain or with another LED CLUBSCAN II when used in master/slave mode.
11. Mains input with IEC socket and integrated fuse holder, connect the supplied mains cable here.
12. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the
mains input of the next Led ClubScan for easier linking.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 20cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
JB SYSTEMS
®
3/38
OPERATION MANUAL
LED CLUBSCAN