Maintenance; Replacement Parts - Dyna-Glo Pro EG7500DGP Instructions D'installation Et D'entretien

1. Before cleaning, make sure the power has been turned off at the circuit breaker
panel and that the heating element of the heater is cool.
2. To maintain the external appearance of the heater, the unit occasionally needs to
be wiped with a dry duster. During the summer months, or at other times when
the appliance is not in use and is completely cold, it should be the wiped over
with a damp cloth.
3. Do not use abrasive cleaning powders or furniture polish. Do not use chemical or
abrasive products, metallic scourers and so on, which may deteriorate the sur-
face, to clean the appliance.
4. During the summer months, or at other times when the appliance is not in use,
disconnect the power supply. Keep the appliance in a dry and cool place.
5. All other servicing should be performed by qualified service personnel. Do not try
to repair the heater yourself.
NOTE: The motor is permanently lubricated, and no further lubrication is needed.
Part Description
Back mesh
1
Hanging plate
2
3 Fan Blade
Air guide plate
4
Large handle seat
5
Small handle seat
6
Spring
7
Motor
8

MAINTENANCE

REPLACEMENT PARTS

Part#
EG5000001AC
EG5000002AC
EG5000003AC
EG5000004AC
EG5000005AC
EG5000006AC
EG5000007AC
EG5000008AC-DGC
Part Description
9 Heater
10 Selection Switch
Thermostat
11
Knob
12
13 Terminal block
Temperature CUT-OFF
14
Caution Indicator (Red)
15
Power Indicator (Yellow)
16
AC Contactor
17
12
Part#
EG7500001AC
EG5000011AC
EG5000012AC
EG5000013AC
EG5000014AC-DGC
EG5000017AC
EG5000018AC
EG5000019AC
EG7500002AC