Ingersoll Rand 170 Manuel D'utilisation Et D'entretien page 2

All manuals and user guides at all-guides.com
Note the position of the reversing lever before
•
operating the tool so as to be aware of the direction
of rotation when operating the throttle.
Use only impact sockets and accessories. Do not
•
use hand (chrome) sockets or accessories.
The use of other than genuine Ingersoll- - Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll- - Rand Authorized
Servicenter.
WARNING
Always wear eye protection
when operating or
performing maintenance
on this tool.
Lubrication
Ingersoll- - Rand No. 10 Ingersoll- - Rand No. 28
(Oil)
For the Ratchet Housing
Ingersoll- - Rand No. 66
Always use an air line lubricator with these tools.
We recommend the following Filter- - Regulator- - Lubricator
(FRL) Unit:
Inside USA use FRL unit # C28- - 04- - FKG0- - 28
Outside USA use FRL unit # C28- - C4- - FKG0
Before starting the tool and after each two or three
hours of operation, unless the air line lubricator is used,
pour approximately 1.5 cc of Ingersoll- - Rand No. 10 Oil
into the air inlet.
Periodically, inject several drops of Ingersoll- - Rand
No. 10 Oil between the Ratchet Housing (39) and Ratchet
Yoke (37) to lubricate the Drive Bushing (36).
Free
Drive
Speed
Model Model
Inches rpm
170 3/8" 160
1770 1/2" 160
Tested in accordance with PNEUROP PN8NTC1.2
H
♦ Tested in accordance with ISO8662- - 1
Using the Tool (Continued)
Whenever the Ratchet Head is installed or
•
repositioned, the Throttle Lever must be positioned
so that reaction torque will not tend to retain the
throttle in the "ON" position.
Ratchet Wrenches are not torque wrenches.
•
Connections requiring specific torque must be
checked with a torque meter after fitting with an
impact wrench.
CAUTION NOTICE
WARNING SYMBOL IDENTIFICATION
WARNING
Read this manual before
operating tool.
PLACING THE TOOL IN SERVICE
Main Line(s) Inner Ø
to be 3X Size of
Air Tool's Inlet Ø
For the Gearing
To Air
System
and
To Air
Tool
(Grease)
Emergency
Shut--Off
Valve
Lubricator
SPECIFICATIONS
Recommended
HSound Level
Torque
dB (A)
Range
ft- - lbs (Nm) Pressure
10- - 60 (14- - 81) 97.8
10- - 60 (14- - 81) 97.8
2
Always wear hearing
protection when operating
this tool.
Installation
Branch Line(s) Inner Ø
to be 2X Size of
Air Tool's Inlet Ø
R
L
F
Regulator Filter
FRL
Drain Regularly
Compressor
(Dwg. TPD905- -2)
Inlet
♦Vibrations
Connec-
Level
tion
Thread
2
Power m/s
Type
110.8 3.9 1/4" NPT
110.8 3.9 1/4" NPT
WARNING
Minimum
Inside Ø
Air Hose
Inches
(mm)
1/4 (6.35)
1/4 (6.35)