Publicité
T-Connector Wiring Kit
INSTALLATION INSTRUCTIONS
1. Read instructions thoroughly before beginning.
2. Locate the vehicles factory OEM trailer light wiring
harness. On vehicles equipped with a factory 7-way connector,
the harness will be attached to the hitch on the left (driver's)
side at the rear of the vehicle
(Fig. 1). For vehicles without
factory tow wiring connectors,
the harness will be located under
the vehicle along
the left (driver's) side frame rail
near a cross member (Fig. 2).
The harness will have a
connector similar to that on the
end of the T-Connector.
For Vehicles With an OEM
Factory 7-Way Connector:
3. Separate the 7-Way connector from the
vehicle wiring harness. Carefully remove the
grey locking tab (fig. 3A) and gently pull
the connector
and harness apart while holding down on
the connector locking latch (Fig. 3B)
taking care not to damage the locking
tabs.
B
A
Fig 1
Fig. 2
Fig. 3
Publicité
