Steelcase Alimentation modulaire universelle Directives D'assemblage page 8

®
1. Place the block with the infeed connector port facing
the direction of the power outlet that will power the system.
2. For Standard Application:
a) Screw the distribution blocks onto the underside of the desks.
The blocks must be located 7"/180mm from the perimeter.
NOTE: location of the distribution blocks (grey) should be based off
the central location of the user power it will connect.
For Use with Universal Cable Tray:
b) Attach the distribution block to the distribution block adapter with
provided fasteners. Slide the distribution block adapter into the tray's
t-slots.
3. Connect each desk to one another by installing the jumper cords to the
infeed/jumper ports of the distribution blocks. Press until tabs lock into place.
3
Height Adjustable Desks
1
Infeed Port
User Power
Port
2a
2b
9.5mm
3/8"
2x
Doc # 160136 Rev C
19mm
7/8"
2x
Page 8 of 23
P/n 1468305001