Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
π
H-5647
STAINLESS STEEL
ROTARY DRUM PUMP
TOOLS NEEDED
1/2" Wrench
IMPORTANT! This pump is made out of 304 stainless steel and PTFE. Use liquids compatible with pump
component materials. Follow OSHA guidelines when using this pump, including proper grounding and
protective gear as required. For a full list of materials and compatible chemicals, see uline.com.
Unit not UL or FM approved.
1.
Rotate handle clockwise several times to prime. If
unit does not prime after a few turns, pouring some
fluid into pump inlet may help free pump.
2. For siphoning, position handle straight down.
3. To stop siphoning, rotate handle 1/4 turn (leave
handle in horizontal position).
PAGE 1 OF 9
1-800-295-5510
uline.com
Flathead Screwdriver
SPECIFICATIONS
Pump Type
Flow
Maximum Fluid Temperature
Bung Adapter
Suction Tube Length
Inlet
Outlet
Wetted Parts
Maximum Viscosity
OPERATING INSTRUCTIONS
Rotary – Vane
10 GPM
140°F / 60°C
2" Male
40" Maximum
1⁄" O.D.
1" O.D. Curved Spout
304 Stainless Steel, PTFE
1,000 cps
4. After using pump, position handle straight down.
Liquid will drain back into the container.
5. If pump is removed from drum, rinse it thoroughly in
a liquid that is compatible with both the pump and
the fluid being pumped.
6. Regularly check pump and suction tubes for leaks.
Leaks in the suction line or in pump housing will
cause inefficient pumping and loss of prime.
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
0123 IH-5647
Publicité
Table des Matières
Manuels Connexes pour Uline H-5647
Sommaire des Matières pour Uline H-5647
- Page 1 IMPORTANT! This pump is made out of 304 stainless steel and PTFE. Use liquids compatible with pump component materials. Follow OSHA guidelines when using this pump, including proper grounding and protective gear as required. For a full list of materials and compatible chemicals, see uline.com. Unit not UL or FM approved.
-
Page 2: Assembly And Installation
ASSEMBLY AND INSTALLATION DESCRIPTION QTY. Discharge Spout Barb Spout Casing Rotor Assembly Vane Spring Spring Rod Lip Seal O-RIng Front Cover Cap Screw Crank Arm Handle Bung Adapter Thumb Screw Cap Screw Handle Shaft Hex Nut Tail Pipe Suction Tube NOTE: Teflon tape should be applied to all 5. - Page 3 PTFE Spray into discharge spout and flush (ex: WD40). Not pumping If low levels of liquid in drum, may require increased RPM for intake. 1-800-295-5510 uline.com PAGE 3 OF 9 0123 IH-5647...
- Page 4 Para obtener una lista completa de los materiales y los químicos compatibles, vea uline.mx. La unidad no tiene aprobación de UL y FM. 1. Gire el asa en dirección de las manecillas del reloj 4.
-
Page 5: Ensamble E Instalación
ENSAMBLE E INSTALACIÓN DESCRIPCIÓN CANT. Boquilla de Descarga Boquilla Cubierta Ensamble del Rotor Aspas Resorte Varilla del Resorte Sello del Reborde Anillo Tórico Tapa Delantera Tornillo de Cabeza Manivela Adaptador de Tapón Tornillo Moleteado Tornillo de Cabeza Eje del Asa Tuerca Hexagonal Tubería de Escape Tubo de Succión... -
Page 6: Solución De Problemas
(por ejemplo, usando WD40). No bombea Si el nivel de líquido en el tambo es bajo, es posible que se requiera aumentar los giros por minuto. 800-295-5510 uline.mx PAGE 6 OF 9 0123 IH-5647... -
Page 7: Pompe À Baril Rotative En Acier Inoxydable
Suivez les directives OSHA lors de l'utilisation de cette pompe, y compris la mise à la terre appropriée et au besoin, le port d'équipement de protection. Reportez-vous au site Web uline.ca pour consulter la liste complète des matériaux et produits chimiques compatibles. Cet article n'est pas homologué... -
Page 8: Assemblage Et Installation
ASSEMBLAGE ET INSTALLATION DESCRIPTION QTÉ Goulotte orientable Bec à raccord cannelé Boîtier Rotor Palette Ressort Tige à ressort Rondelle d'étanchéité Joint torique Couvercle avant Vis d'assemblage Bras de manivelle Poignée Adaptateur de bonde Vis de serrage Vis d'assemblage Arbre de poignée Écrou hexagonal Tuyau d'échappement Tube d'aspiration... -
Page 9: Dépannage
PTFE (p. ex. : WD40). Aucun pompage Si le niveau de liquide dans le baril est bas, il peut être nécessaire d'augmenter les tours par minute pour le siphonnage. 1-800-295-5510 uline.ca PAGE 9 OF 9 0123 IH-5647...