aermotor SPCA Serie Manuel D'installation Et D'utilisation page 4

HORIZONTAL PIPING FROM WELL TO PUMP
1. Never install a suction pipe that is smaller than the
suction port of the pump.
2. To aid priming on well point installations, install a
line check valve as shown in Figure 2. Be sure
check valve flow arrow points toward pump.
DISCHARGE PIPE SIZES
1. If increasing discharge pipe size, install reducer in
pump discharge port. Do not increase pipe size by
stages.
2. When the pump is set away from the points of water
use, the discharge pipe size should be increased to
reduce pressure losses caused by friction.
• Up to 100' run: Same size as pump discharge port.
• 100' to 300' run: Increase one pipe size.
• 300' to 600' run: Increase two pipe sizes.
LAWN SPRINKLING APPLICATION
This pump is designed for lawn sprinkling. It is de-
signed to deliver plenty of water at full sprinkler pres-
sure. It can pump from a pond, cistern or well points.
Pump discharge can be divided to supply two (2) or
more sprinkler systems. A suggested multiple dis-
charge to service is shown in Figure 3.
Do not use in a pressure tank or booster pump
application.
4 0 6 0
2 0
8 0
1 0 0
Figure 3 – Multiple Discharge
All manuals and user guides at all-guides.com
PUMP INSTALLATION
NOTICE: Use only Teflon tape or Teflon based joint
compounds for making all threaded connections to the
pump itself. Do not use pipe joint compounds on
plastic pumps: they can react with the plastic in the
pump components. Make sure that all pipe joints in the
suction pipe are air tight as well as water tight. If the
suction pipe can suck air, the pump will not be able to
pull water from the well.
1. Bolt pump to solid, level foundation.
Figure 4 – Bolt Pump Down
2. Support all piping connected to the pump.
Figure 5 – Independently Support All Piping Attached
to Pump
4
Pump/Piping Installation
6 0
4 0
2 0
8 0
1 0 0