Dry Ironing; Care And Cleaning - Aigostar 8433325501136 Manuel D'instructions

been reached.
BURST OF STEAM
This function provides an extra amount of steam to remove stubborn wrinkles.
 Fill the iron with water as described on page 3.
Turn the temperature control to the position "MAX"

The pilot light turns off when the required temperature is reached

The iron is ready for use

Press the Burst of Steam button (5) once

Steam will penetrate into the garment removing the wrinkles

Wait a few seconds before pressing the steam control knob again when there are

stubborn wrinkles
Usually all wrinkles can be removed within three pressings

DRY IRONING

Connect the iron to a suitable mains supply outlet.

Ensure that the steam control knob(3) is in position"0"

 Select the setting on the temperature control dial(6).
When the pilot light turns off, the required temperature is reached. The iron is ready

for use.

CARE AND CLEANING

1. Turn the temperature control dial(6) to "OFF", then disconnect the iron from the wall
outlet and let it cool down completely.
2. Deposits and other residues on the sole plate can be removed with a cloth soaked in a
vinegar/water solution.
3. The casing may the wiped with a damp cloth and then polished with a dry one.
4. Never use any abrasives to clean the sole plate.
5. Keep the sole plate smooth; avoid contact with metal objects.
STORAGE
Turn the temperature control dial(6) to "OFF" and set the steam control knob (3) to

position"0"(=no steam).
Disconnect the iron from the wall outlet.

Pour any remaining water out of the water tank.

Stand the iron upright and let it cool down completely.

The power cord can then be round around the iron.

 Always store the iron in an upright position.