Reese 30923 Instructions page 5

FOR INSTALLATION WITH M5
HEAD AND CENTER SECTION
7. Due to variations in truck underbeds, it is normal for some handles to be loose and other handles to be too tight to lock. If a
handle appears to loose and rattles or cannot be closed fully, remove the lynch pin and adjust castle nut by hand to a
position where handle does not rattle or is able to close.
8. Once handle adjustment is satisfactory, re-insert lynch pin and close loop over nut to hold in place. Additional cotter pins
are provided in the hardware kit for your convenience.
9. With Ford Leg T-Pin handles locked and T-Pins securely held in underbed structure, tighten each M16 hex-head bolt to
220 ft-lb of torque.
10. Verify that hitch is tight to truck bed by lifting each side of the hitch.
11. Assemble head to center section per instructions included with M5 Center Section and Head.
©
2018 Horizon Global America Inc.
Product Instructions
M5 FORD LEG
Page 5 of 21
Finger tighten castle nut only!
(Do not install lynch pin
until final adjustments
are made)
06/21/2022
30923N 08/15/2018
Part Number:
30923
Rev. B
Rev. A