Yakima HullyRollers Mode D'emploi page 3

Release brakes on rollers by
pulling and turning to the left.
Install a second pair of Hully
Rollers, Mako or LandShark
Saddles on FRONT crossbar.
seT The
roller
brakes:
Pull tab out and
to the right while
rocking boat
gently until the
brake tabs nest.
TighTen sTraps
Insert end of plain
strap into buckle
as shown.
secure front and rear of boat to
vehicle with bow/stern tie downs.
Refer to bow/stern tie down instructions for correct
assembly and installation.
beFore driving away
• Test movement by rocking boat.
• Tighten again if loose.
• READ ALL CAUTIONS AND LIMITS ON NEXT PAGE.
1033393A-3/12
Position boat hull on rear
rollers, and slide boat
onto vehicle.
insTall sTraps
Holding the buckle end, pass a strap over the
boat, and under each crossbar.
PULL STRAP
ENDS TO
TIGHTEN.
Failure to secure front and rear of long loads to
ends of vehicle can result in property damage,
personal injury, or death.
You may need to loosen the attachments
and slide rollers inboard or outboard so
that rollers rest against the hull.
Always pass the strap
inboard to the tower.