Sauder 416405 Instructions D'assemblage page 8

Step 5
Fasten two NON-SWIVEL CASTERS (8CN) to the front
å
corners of the BOTTOM (C). Use eight BROWN 7/16"
LARGE HEAD SCREWS (6S).
Fasten two SWIVEL CASTERS (8CS) to the back
å
corners of the bottom. Use six BROWN 7/16" LARGE
HEAD SCREWS (6S).
Fasten the BOTTOM (C) to the ENDS (A). Use four
å
BROWN 1-1/2" FLAT HEAD SCREWS (14S).
NOTE: Two BROWN 1-1/2" FLAT HEAD SCREWS (14S)
å
will go through the SWIVEL CASTERS (8CS), through the
BOTTOM (C), and into the ENDS (A).
BROWN 1-1/2" FLAT HEAD SCREW
(4 used in this step)
These edges
must be even.
Page 8
14S
8CS
C
A
The tabs on the NON-SWIVEL
CASTERS must insert into these holes.
C
8CS
A
416405
8CN
8CN
The wheel must be closer
to the long front edge.
BROWN 7/16" LARGE HEAD SCREW
(14 used for the CASTERS)
www.sauder.com/services
6S