Télécharger
Partager
Imprimer la page
Sauder 410367 Mode D'emploi
  1. Manuels
  2. Marques
  3. Sauder Manuels
  4. Ameublement d'intérieur
  5. 410367
  6. Mode d'emploi
Sauder 410367 Mode D'emploi

Sauder 410367 Mode D'emploi

Masquer les pouces

Publicité

Liens rapides

Télécharger ce manuel
Great for all those books
you'll never read.
5-Shelf Bookcase

Publicité

loading

Manuels Connexes pour Sauder 410367

Sommaire des Matières pour Sauder 410367

  • Page 1 Great for all those books you’ll never read. 5-Shelf Bookcase...

  • Page 2: Table Des Matières

    Table of Contents Assembly Tools Required Part Identifi cation No. 2 Phillips Screwdriver Tip Shown Actual Size Hardware Identifi cation Assembly Steps 5-19 Hammer Not actual size Français 20-23 Español 24-27 Nail Holder (provided) Safety 28-30 Tape Measure Warranty Now you know Part Identifi...

  • Page 3: Part Identifi Cation

    Part Identifi cation Page 3...

  • Page 4: Hardware Identifi Cation

    Hardware Identifi cation å Screws are shown actual size. You may receive extra hardware with your unit. HIDDEN CAM - 12 CAM DOWEL - 12 ANGLE BRACKET - 8 NAIL - 48 CAM COVER - 8 HOLE PLUG - 3 FURNITURE TIPPING METAL PIN - 12 RUBBER SLEEVE - 12...
  • Page 5 Step 1 Assemble your unit on a carpeted fl oor or on the empty å carton to avoid scratching your unit or the fl oor. Just think. The sooner you do this, the sooner Fasten the TOP MOLDING (M20) to the TOP (E3). Use å...
  • Page 6 Hardware Usage Guide HOW TO USE A HIDDEN CAM & CAM DOWEL Cam Dowel Cam Dowel Arrow Metal end Hidden Cam Hidden Cam Insert the metal end of the CAM DOWEL into the HIDDEN CAM. Hole Hole Push a HIDDEN CAM into the part.
  • Page 7 Step 2 Push four HIDDEN CAMS (1F) into the UPPER ENDS (A3 å and B3). Then insert the metal end of a CAM DOWEL (2F) into each HIDDEN CAM. Do not tighten the HIDDEN CAMS in this step. Arrow Metal end Page 7...
  • Page 8 Step 3 Slide the UPPER END MOLDINGS* (K) onto the notched å edges of the UPPER ENDS (A3 and B3). NOTE: The bottom edges of the ENDS and MOLDINGS å should be even. *U.S. Patent No. 5,499,886 å Notched edge The large groove is Notched edge closer to this edge.

  • Page 9: Safety

    Step 4 Fasten the UPPER ENDS (A3 and B3) to the TOP (E3). å Caution Tighten four HIDDEN CAMS. Do not stand the unit upright without the NOTE: Be sure the END MOLDINGS (K) are touching the å BACK fastened. The unit may collapse. TOP MOLDING (M20).
  • Page 10 Step 5 Fasten the SHELF (G3) to the UPPER ENDS (A3 and B3). å Use four BLACK 1-15/16" FLAT HEAD SCREWS (113S). Side Step: Make nachos. (Optional, but NOTE: You should start each SCREW a few turns before å recommended.) completely tightening any of them.
  • Page 11 Step 6 Push four HIDDEN CAMS (1F) into the LOWER ENDS (C2 and D2). Then insert the metal end of a CAM DOWEL (2F) into å each HIDDEN CAM. Slide the LOWER END MOLDINGS* (P) onto the notched edges of the LOWER ENDS (C2 and D2). å...
  • Page 12 Step 7 Fasten the LOWER ENDS (C2 and D2) to the SHELF (G3). å Tighten four HIDDEN CAMS. NOTE: Be sure the LOWER END MOLDINGS (P) are å touching the SHELF (G3). i t h f a c S u r D E N H I D i t h o...
  • Page 13 Step 8 Fasten three ANGLE BRACKETS (5G) to the SHELF (G3). å Use three BLACK 9/16" LARGE HEAD SCREWS (1S). Fasten the SKIRT (O) to the SHELF (G3). Use three å BLACK 9/16" LARGE HEAD SCREWS (1S). NOTE: There are no pre-drilled holes in the SKIRT. The å...
  • Page 14 Step 9 Push four HIDDEN CAMS (1F) into the BOTTOM (F). Then insert å the metal end of a CAM DOWEL (2F) into each HIDDEN CAM. Fasten three ANGLE BRACKETS (5G) to the BOTTOM (F). Use å three BLACK 9/16" LARGE HEAD SCREWS (1S). NOTE: Be sure the edges of the ANGLE BRACKETS are even with å...
  • Page 15 Step 10 Fasten the BOTTOM (F) to the LOWER ENDS (C2 and D2). å Tighten four HIDDEN CAMS. Almost time to NOTE: You may need to fl ex the LOWER ENDS outward å celebrate! With a nap. slightly for the BOTTOM to fi t. Fasten the BASE (M46) to the ANGLE BRACKETS on the å...

  • Page 16: Upper Left End

    Step 11 We have provided a Nail Holder tool to use in this step for proper å Caution positioning of the NAILS. Please refer to the parts of the Nail Holder as the bead, off set edge, and nail slot as shown in Diagram 1. Do not stand the unit upright without the BACK fastened.

  • Page 17: Small Back

    Step 12 Unfold the SMALL BACK (I2) and lay it over the bottom of your unit. å Diagram 1. Place the SMALL BACK (I2) into the edges of the LOWER ENDS (C2 and D2), with the bottom edge of the å...
  • Page 18 Step 13 Carefully stand your unit upright in its fi nal location. We recommend using the SAFETY STRAP for added stability. å NOTE: Do not turn the SAFETY DRYWALL ANCHOR into a wall stud. If you prefer to fasten the SAFETY STRAP to a wall å...
  • Page 19 Step 14 Slide a SHELF MOLDING* (N) onto the notched edge of each ADJUSTABLE SHELF (J). å Push the RUBBER SLEEVES (2R) over the METAL PINS (1R). Insert the METAL PINS (1R) into the hole locations of your å choice in the ENDS (A3, B3, C2, and D2). Set the ADJUSTABLE SHELVES (J) onto the METAL PINS. Using your hammer, gently tap a CAM COVER (13P) onto each visible HIDDEN CAM.
  • Page 20 Bibliothèque 5 tablettes Utilisez les instructions d’ a ssemblage en français avec les NOUS CONTACTER EN PREMIER schémas étape par étape du manuel d’instruction en anglais. AVANT D'EFFECTUER TOUT RETOUR AU MAGASIN. Chaque étape en français correspond à la même étape en Nous faisons de notre mieux pour nous assurer que votre meuble anglais.
  • Page 21 ÉTAPE 1 ÉTAPE 4 Assembler l'élément sur un sol à moquette ou sur le carton vide Attention: Ne pas relever l'élément dans sa position verticale pour éviter d'endommager l'élément ou le sol. avant d'avoir fi xé l’ARRIÈRE. L'élément risque de s'eff ondrer. Fixer la MOULURE DE DESSUS (M20) au DESSUS (E3).
  • Page 22 ÉTAPE 8 ÉTAPE 11 Fixer trois CONSOLES À ÉQUERRE (5G) à la TABLETTE (G3). Attention: Ne pas relever l'élément dans sa position verticale Utiliser trois VIS TÊTE LARGE 14 mm NOIRES (1S). avant d'avoir fi xé l’ARRIÈRE. L'élément risque de s'eff ondrer. Fixer la PLINTHE (O) à...
  • Page 23 ÉTAPE 12 ÉTAPE 13 Déplier le PETIT ARRIÈRE (I2) et le poser sur la section inférieure Relever, avec précaution, l'élément dans sa position verticale et de l’unité. placer l'élément dans son emplacement fi nal. Il est recommandé d'utiliser la SANGLE DE SÉCURITÉ pour renforcer la stabilité. Schéma 1.
  • Page 24 Biblioteca con 5 estantes Use estas instrucciones de ensamblaje en español junto con las CONTÁCTENOS PRIMERO fi guras paso-a-paso provistas en el folleto inglés. Cada paso en ANTES DE HACER DEVOLUCIONES A LA TIENDA. español corresponde al mismo paso en inglés. Compare la “Lista Tratamos de asegurar que su mueble llega en condición excelente.
  • Page 25 PASO 1 PASO 4 Ensamble la unidad sobre un piso alfombrado o sobre el cartón Precaución: No coloque la unidad en posición vertical hasta que se vacío para evitar rayar la unidad o el piso. fi je el DORSO. La unidad podría caerse. Fije la MOLDURA DE PANEL SUPERIOR (M20) al PANEL Fije los EXTREMOS SUPERIORES (A3 y B3) al PANEL SUPERIOR (E3).
  • Page 26 PASO 8 PASO 11 Fije tres SOPORTES ANGULARES (5G) al ESTANTE (G3). Utilice Precaución: No coloque la unidad en posición vertical hasta que se tres TORNILLOS NEGROS DE CABEZA GRANDE de 14 mm (1S). fi je el DORSO. La unidad podría caerse. Fije el FALDÓN (O) al ESTANTE (G3).
  • Page 27 PASO 12 PASO 13 Despliegue el DORSO PEQUEÑO (I2) y colóquelo sobre la parte Cuidadosamente ponga la unidad en posición vertical y coloque inferior de la unidad. su unidad en su posición fi nal. Se recomienda que utilice la CORREA DE SEGURIDAD para aumentar la estabilidad. Gráfi...
  • Page 28 WARNING Please use your furniture correctly and safely. Improper use can cause safety hazards, or damage to your furniture or household items. Carefully read the following chart. Look out for: What can happen: How to avoid the problem: • Overloaded shelves. •...
  • Page 29 AVERTISSEMENT Prière d’utiliser le mobilier à bon escient et avec prudence. Une mauvaise utilisation peut être à l’ o rigine de risques d’ a ccident ou peut endommager le mobilier et les articles ménagers. Lire attentivement le tableau suivant. À surveiller : Danger éventuel : Solution : •...
  • Page 30 ADVERTENCIA Por favor use el mobiliario correcta y seguramente. El mal uso puede causar riesgos de seguridad o daño a las unidades o artículos domésticos. Cuidadosamente lea la tabla a continuación. Esté alerto de: Puede ocurrir: Evitar el problema: • Estantes sobrecargados. •...
  • Page 31 5-YEAR LIMITED WARRANTY 1. We provides limited warranty coverage to the original purchaser of this product for 4. This Warranty applies only to warranted defects that fi rst arise and are reported a period of five years from the date of purchase against defects in materials or to within the warranty coverage period.
  • Page 32 CONTACT US FIRST BEFORE MAKING ANY RETURNS TO THE RETAILER. Dear Valued Customer: So, how did it go? Thanks so much for choosing our furniture. I hope the Set a world record for speed? purchase and assembly process was a positive experience Feeling good about yourself? and you feel good about the furniture you just built.